Recent content by AZ_Hardwoods
-
01 EB rear wiper not working
I have an ajar warning when i am working on it but that is because I have the drivers door open. That shouldn't be a problem. I will have to get back to this one in a minute. I am currently trying to figure out how to get the ac compressor out. If it ain't one thing with this truck it is another.- AZ_Hardwoods
- Post #8
- Forum: Electrical
-
01 EB rear wiper not working
I'm just starting out where the DVD told me to start troubleshooting. Perhaps it is just that wrong.- AZ_Hardwoods
- Post #4
- Forum: Electrical
-
01 EB rear wiper not working
My rear wiper does not work. I get no power back at the motor. I have tested the fuses it calls for under the hood, number 103 and get over 10 volts there and number 15 under the dash and I can't seem to get a reading there. Problem with that though is that when I plug the fuse back in after...- AZ_Hardwoods
- Thread
- Replies: 8
- Forum: Electrical
-
Raw gas smell from exhaust
I will have to find some time to look at these different options. I would think if the cats were shot, that there would be a code for sure. Startup is just fine. Turns over and starts right up. Idles at about 700 - 800 rpm once it warms up. Gas smell truly seems to be contained to the exhaust...- AZ_Hardwoods
- Post #3
- Forum: 1st Gen - 1997 - 2002
-
Raw gas smell from exhaust
I am getting a raw gas smell from my exhaust at all times. It is there when warming up and when up to temperature. There are no codes popping up. I don't smell it coming through the vents when the A/C or heater are going. It is a 2001 EB 4x4 5.4L. Any ideas on things to check? I have a code...- AZ_Hardwoods
- Thread
- Replies: 4
- Forum: 1st Gen - 1997 - 2002
-
2001 Expedition too many issues to list
Ok, so I have figured out the horn situation. It has a TSB for it. They say it should take an hour. My guess is it will take me three hours at some point.- AZ_Hardwoods
- Post #18
- Forum: 1st Gen - 1997 - 2002
-
2001 Expedition too many issues to list
Got the pedals moved all the way forward. I think I will just have buy new pedals at some point if I want them to work. I think the gears inside the housings are stripped out some. Discovered a new fun problem though. I wondered why when I doubled locked the door with the key fob that the horn...- AZ_Hardwoods
- Post #17
- Forum: 1st Gen - 1997 - 2002
-
2001 Expedition too many issues to list
The seat is now fixed. I added a little bit of lithium grease to the track which seems to help some. I also discovered that for some reason if the seat is completely lowered using the down button then it won't move forward past a certain point. If you raise the seat a 1/4" to a 1/2" inch it...- AZ_Hardwoods
- Post #16
- Forum: 1st Gen - 1997 - 2002
-
2001 Expedition too many issues to list
Alright so a little update with this project. The driver side headlight was missing an adjuster screw and wouldn't sit right so I replaced the housing and everything is all good. The power mirrors now work after a switch replacement. The headlights work again. It wasn't the main light switch or...- AZ_Hardwoods
- Post #15
- Forum: 1st Gen - 1997 - 2002
-
2001 Expedition too many issues to list
Ok, so the 4x4 switch checked out fine but I also tested that yesterday. Tested it again to be safe. I tested the main light switch and it has no resistance value on the dimmer. Then I fiddled with it again and it did have a resistance value on the dimmer. I got fed up with it and threw it back...- AZ_Hardwoods
- Post #13
- Forum: 1st Gen - 1997 - 2002
-
2001 Expedition too many issues to list
Thank you for the diagrams. I have tested everything and am a little confused by something. The last test for the panel lamp dimmer circuit is failing. I can not get a reading at all when I have the voltmeter on pins 1 and 6. Now this may be my problem on why the dimmer is blowing when I use the...- AZ_Hardwoods
- Post #11
- Forum: 1st Gen - 1997 - 2002
-
2001 Expedition too many issues to list
It may have been in an accident but it probably wasn't reported. It was just old and not well maintained. At this point, I have figured out it is just a transmission issue. So that will be quite expensive. The rest is probably just a lot of motors that need to be replaced. Slowly but surely, it...- AZ_Hardwoods
- Post #7
- Forum: 1st Gen - 1997 - 2002
-
2001 EB trans or transfercase?
Well here is an interesting find. I pulled every fuse in the junction box while having the multi meter hooked up to fuse #18. Nothing made the 9V of power go away. However a couple made it become a negative nine volts and one or two made it become like 15V. However the most interesting thing was...- AZ_Hardwoods
- Post #20
- Forum: Transmission & Drive train
-
2001 Expedition Eddie Bauer 4x4 switch blows #18 junction box fuse
You can feel free to delete it. I just figured I should put it where it belonged. Not trying to mess up your forum or nothing.- AZ_Hardwoods
- Post #3
- Forum: Electrical
-
2001 Expedition Eddie Bauer 4x4 switch blows #18 junction box fuse
I have a problem where when I change the 4x4 mode of my vehicle the the #18 fuse in the junction box blows. That fuse controls the back light of the dash. I have tested the fuse port with volt meter while having the main light switch in the on and off position. When the main light switch is off...- AZ_Hardwoods
- Thread
- Replies: 4
- Forum: Electrical
