Well I am still working on my brake lines. I got the lines from the ABS to the master cylinder off ebay for $30. they were 1/4" lines. I got my connector for the last fitting I couldnt find also off ebay by buying a used abs module that had the same configuration as mine brake line wise...
well to be straight about it the lines coming from the master cylinder are not 3/16ths. I went to napa but they weren't much help. On the bright side ebay has both lines from the master cylinder in stainless steel lines for $30. So I ordered them just because I'm tired of running around trying...
Thanks for that info. Yes I have a mastercool flaring tool that does bubble flares. I have used Bubble flares on everything for the brakelines so far. I will keep an eye on this post.
Does anyone know what diameter brake line is used between the master cylinder and the abs unit on the 2006 expedition? Also looking for the flare nuts size as well. I am using the copper nickle tubing to replace the lines going to the wheels however the lines running from the master cylinder to...
I'm in the middle of replacing my brake lines on my 06 expedition. I can recommend the nickle copper alloy brake line. Its great to work with. I also wrapped much of it with the stainless steel coil for protection from road debris. I bought a Mastercool hydraulic flaring tool. Works great in...
Thanks for the replys. Looks like I am going with option 2. I don't really care how the outside looks because you really can't see it. I just thought it would be a good idea to wipe out the inside but it seems that is not an option right now. The front differential sounds like it will be even...
I'm planning on replacing the rear differential fluid in my 2006 expedition which has 4 wheel drive. I'd like to remove the cover and clean out the housing before I replace the fluid. There isn't much clearance by the cover. Is it possible to remove the cover for cleaning by just removing the...
Any views on what to apply to the existing rust on the frame to slow it down? I've read POR15 but i've never used it. I have used some stuff by Eastwood.
I saw that and almost went that route but since I was looking for 4 connectors I just decided to replace the radiator with this one.https://www.amazon.com/gp/product/B004LGPHE8/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1 for $135 and most of the reviews weren't bad. I will probably use that...
Run into another issue. Quess I've read it elsewhere but Ford doesn't sell the quick connect fitting that goes in the radiator separately. You can only purchase a new radiator with the connectors. The one that Dorman shows doesn't look like the correct part. Anyone figured this out?
Well the lines at the radiator connectors were corroded so badly ended up cutting the lines to remove them. So that then required a 27mm socket to remove the screw in connectors. waiting on replacements showing up hopefully I ordered the correct item. 7L3Z-7D273-A is supposed to be the new...
Well not doing any towing so I am planning on leaving the cooler alone. Right now removing the lines from the transmission is a bit of a challenge as there is not much room around there. I'll see about taking some pictures tomorrow.
Well I just found out that I need to replace my transmission cooling lines due to rust. Its an 06 xlt. Are there any other lines or parts that are prone to rust on the expedition? Basically its been a pretty solid vehicle. I'm going to replace the transmission filter while I'm at it. So it is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.