Recent content by PCDS
-
P
Suggestions on fixing bent bumper corner???
Used boiling water to soften the plastic nothing hotter we know the boiling water is 212°. That's enough to get the plastic soft but not enough to do any damage to anything else you will need two epoxy it in place a good six to eight inches back towards the rear of the car. You will need a clamp...- PCDS
- Post #5
- Forum: 4th Gen - 2018 - 2024
-
P
ERB caliper piston won't budge...
Thanks for the replies. Problem wasn't that the vehicle was not in "maintenance" mode. It was. It took a couple of cycles of pressing the gas, lifting the P brake button then pressing the start button 4 times. But the message came up, in Maintenance mode. When I finished up and took it out...- PCDS
- Post #5
- Forum: 4th Gen - 2018 - 2024
-
P
ERB caliper piston won't budge...
Trying to do pads on 2020 Max. It says it is in Brake Maintenance Mode on the dashboard but the puck will not go in at all. I have the tool. Any thing I could be missing? I had problems getting it into maintenace mode, had to try several times but now the light says it is in. I also have an...- PCDS
- Thread
- Replies: 4
- Forum: 4th Gen - 2018 - 2024
