Recent content by pdaoaudio
-
P
03 XLT Possible ignition problem??????
Well I fixed it, ended up being a loose ground that was causing all the mess, When i first checked i only checked to see if the terminal connection was tight, not the individual wires, all is well and running like it was before!!!- pdaoaudio
- Post #11
- Forum: 2nd Gen - 2003 - 2006
-
P
03 XLT Possible ignition problem??????
As soon as The I try to crank the truck I lose all power and it doesn't restore unless i re-cycle the key so I would not have power there nor anywhere through the electrical system if the key was being turned to start.- pdaoaudio
- Post #9
- Forum: 2nd Gen - 2003 - 2006
-
P
03 XLT Possible ignition problem??????
Yes I have a multimeter and shouldnt have any issue using it- pdaoaudio
- Post #7
- Forum: 2nd Gen - 2003 - 2006
-
P
03 XLT Possible ignition problem??????
Also for the heck of it pulled the relay for the ignition the truck acts normal is it would with a normal start electrical wise, dings and power restores after you turn the key. swapped it with the same relay from my ranger and it goes back to the same thing- pdaoaudio
- Post #5
- Forum: 2nd Gen - 2003 - 2006
-
P
03 XLT Possible ignition problem??????
UPDATE! : Key in the ignition door dinger goes off, put key in the accessories position and relay clicks, radio comes on etc, turn the key to the on position relay clicks, fuel pump powers, gauge lights come one, go to start, relay clicks, sounds like starter solenoid clicks then I lose all...- pdaoaudio
- Post #4
- Forum: 2nd Gen - 2003 - 2006
-
P
03 XLT Possible ignition problem??????
I will give it a check shortly. If it isnt that what else could it be? Is next up to bat the ignition switch?- pdaoaudio
- Post #3
- Forum: 2nd Gen - 2003 - 2006
-
P
03 XLT Possible ignition problem??????
Ok so I went get in my truck to leave for work today and had to drive my ranger in instead since it would not start. Here is everything I can tell you at this point in time: Truck unlocks with my remote fine, open the door and the interior lights go on as well as my puddle lights. I...- pdaoaudio
- Thread
- Replies: 10
- Forum: 2nd Gen - 2003 - 2006
-
P
03-06 Expedition fender flares for XLT ????????
it kills me they pretty much make them for every truck known to man but ours, like really? wish they would have make the eddie bower/ limited bumpers the same style as ours and make the flares fit all sub models ..... :321::think:- pdaoaudio
- Post #3
- Forum: After Market Add-Ons
-
P
03-06 Expedition fender flares for XLT ????????
I am driving myself nuts looking for a set of fender flares for my 03 xlt. The problem Im having is all that I can find to come up is the eddie bower/ limited oem flares which will not work with the xlt cladding. If i went that route i would be buying both front and rear bumpers and Im not...- pdaoaudio
- Thread
- Replies: 4
- Forum: After Market Add-Ons
-
P
2003 4.6 expedition P0171, P0141 P0138 Rough Idle???
Ok well today I started to poke around the truck today.... 6 degrees out with about -20f wind chill..... to say the least I am frozen and not very happy. I got to the bottom of my whining noise. I replaced my idler pulleys and away my whine went! Come to my surprise when I was taking off my...- pdaoaudio
- Post #5
- Forum: 2nd Gen - 2003 - 2006
-
P
2003 4.6 expedition P0171, P0141 P0138 Rough Idle???
My bet is a vacuum leak. I noticed i get a release of pressure noise when the engine is shut off, I will have to further find out exactly where that noise is coming from. I will update that tomorrow after work. Im going to start with the basics, check the fuel filter, clean the MAF sensor and...- pdaoaudio
- Post #4
- Forum: 2nd Gen - 2003 - 2006
-
P
2003 4.6 expedition P0171, P0141 P0138 Rough Idle???
Im no mastertech but I can correct any issues myself or with minimal help from a mechanic friend of mine.- pdaoaudio
- Post #3
- Forum: 2nd Gen - 2003 - 2006
-
P
2003 4.6 expedition P0171, P0141 P0138 Rough Idle???
Hey everyone, Trying to find some info on these codes and how to go about fixing them. I have been rarely driving my truck since my new work commute is 70 miles round trip most days I have been driving my ranger for the majority of the time. The expedition gets driven on bad winter days and my...- pdaoaudio
- Thread
- Replies: 4
- Forum: 2nd Gen - 2003 - 2006
-
P
Custom 2003 XLT Stereo Demo Vehicle build !!!!!!!
I will try and get you a list of what I ordered by the end of the day, i will look through my receipts and see if i still have the invoice. I know I did not replace my headliner center counsel lights because I did not out it back in due to the stereo, it would just knock it out all the time.- pdaoaudio
- Post #38
- Forum: Member Photos
-
P
Custom 2003 XLT Stereo Demo Vehicle build !!!!!!!
Walled Expedition hair trick with 5 15s - YouTube https://www.youtube.com/watch?v=cGZB-slmo0M- pdaoaudio
- Post #37
- Forum: Member Photos
Latest posts
-
Odd vibration/rattle from engine (?) on incline in higher gear
- Latest: 99WhiteC5Coupe
-
-
-
-
