So I am very confused !! So is there anybody out there that can positively say that the front driveshafts DO NOT SPIN IN 2WD.
Also am I or is Alldata wrong???? Does the front IWE have to have vacuum to be engaged or disengaged
I don't know who is right. I know that on my 2005 BOTH of my front axles turn in 4wd or 2wd. So maybe mine is screwed up and I don't know it. This is what Alldata says
End (IWE) System
The integrated wheel end (IWE) system contains the following:
•Vacuum reservoir
•IWE solenoid...
those plugs are gapped at the factory. You should have no reason to set the gap. And as for plugs,I prefer to stick with Motorcraft , but it is up to each owner on what they want to use
--------------------------------------------------------------------------------
I don't know if most people know this but you can make a Tire Pressure Reset tool.If you have a old Speaker laying around take and brake the magnet off of the back. Then take and break it in half again. Now take...
If you have a old Speaker laying around take and brake the magnet off of the back. Then take and break it in half again. Now take the magnet and set it by the tire valve stem, now make sure your ingnition switch is turned on and then wait for the horn. You know that you will have to go to each...
If it was mine I would get a attorney. With it having only 47 miles, I would want a new vehicle. Just like was stated if you go to trade or sell that Carfax stays with the vehicle. I know that Body Shops these days can fix just about anything,but that is not the point. You and your family bought...
Well I called Ford yesterday 6/10 and I have not heard back from them. I really don't want to hear from them,I know it is going to Piss Me Off. This is a bulliten ya'll might want to read from Ford,so with this bulletin Ford knows there is a problem!!! Look at when this bulliten was sent out...
Sounds like you have a bad connection. I would do like Moemantha and double check your connections at the battery. Did you take any connections loose when you changed the plugs?
I have been tapping the motor itself,not where the gear is and not the transfer case, just the motor. I tapped on it Friday as I was changing oil and that afternoon NO HI or LO. The part that floors me is that I can put it in
A4WD and spin the rear the front locks in like it is suppose too.
Yes I had the same noise on the Passenger door. I took and adjusted the black striker on the B-pillar,just a little in and up. That fixed two problems. The squeak is gone,and now my door lines up perfectly. I can't stand a noise that had that sound,like finger nails on a chalk board
Well you can always make phone calls to see if there is another shop that will do the labor. I think you can buy a Motorcraft fuel filter from O'reilys for $12.00 so I would look for that locally. Money is hard to come by these days so if you can save $5.00's here and $10.00's there it adds up...
It states in the manual that you have to drive about 500 miles before the distance to empty and the fuel gauge will be sorta close. I have been about 350-380 miles before I find a gas station. I think that when I filled up it only took like 18-20 gallons so there is a few gallons left when you...
Well I have a 2005 Expedition 4x4. When I bought this in March I came to this website to find out what to look for before stepped up to the pump. Well just like was talked about the 4x4 would not go to 4HI or 4Lo. I used it as a buying point for a lower price which also worked. when I got home I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.