Recent content by Russell Lewis

  1. R

    No Heat Tried everything

    Feel the hoses make sure warm. If only 1 side it’s a plugged core. If both sides it’s the door check vacuume lines
  2. R

    How Do I Place Jack Stands?

    Frame is the best/strongest holding point unless you need room under the rear ended than under axles at spring perch or shock bolt
  3. R

    What’s This Plug

    If no air suspension that’s it the compressor is under the wiper fluid. Ford because they make so many cars has wire harness pre made if something does not apply they just don’t hook up. A friend told me they added turn single mirrors because had the harness for it just no mirror. If you don’t...
  4. R

    Non-dorman Intake manifold

    Felt like made my f250 5.4 same better gas mileage more torque.
  5. R

    First truck only 17 need help from Chevy to ford yahh

    On plugs make sure to do rubber boots and the coil spring in the middle mine were all dirty. Do the trans also most over looked fluid yet one of most expensive issues if breaks, being in Huston check Freon to make sure good to go you need a/c, coolent flush. I also do 100% new break fluid it...
  6. R

    2001 EB 5.4, passenger door lock behind driver does not lock/unlock electrically

    Sounds like a bad door Actuator. If you want to check Actuator or switch pull panel use volt/ohms reader put both probes to the prongs on the switch should read 1 ohm the togle switch either way should read 0 or .x Showing no resistance. To make sure it’s Actuator easy just make sure power. If...
  7. R

    2001 EB 5.4 hear 1 click on start attempt but no cranking..new battery

    Little humor for you. Your colder then Alaska lol
  8. R

    2001 EB 5.4 hear 1 click on start attempt but no cranking..new battery

    Check voltage when happening. Depending how cold it it might make things sluggish different temps between the 2 times ?
  9. R

    Infamous "rubbing noise"

    What’s rubbing ? Where is it coming from ? Little more info would help other then that it’s your muffler bearing.
  10. R

    FPDM location

    Took it off you can brake clean to clear all junk off. Or I did the easy way Berryman b12 injector cleaner poured in a little bowl used a nylon bottle brush that way kill 2 birds 1 stone after clean dump rest in gas tank. If caked on carbon like hers, once you pore in let it sit with the fluid...
  11. R

    FPDM location

    Sounds like a EGR problem. Similar issues on wife’s van P0401 does yours have a CEL or a pending code?
  12. R

    Non-dorman Intake manifold

    Very good detailed write up on th Ldm one. Best pictures to show what I was talking about.
  13. R

    2000 Eddie Bauer 5.4L

    What did the shop say the problem was?
  14. R

    Non-dorman Intake manifold

    In my opinion having replaced one. Holding side by side the dorman has a bigger air box between the heads on the bottom, don’t know but might have given better air flow. On my 5.4
  15. R

    Oasis Report

    Done by a dealership service department ask them, most charge for it though. Getting a “ free “ one can be had from someone you know or a friend of a friend. Check ford truck enthusiasts sometimes you can ask there just give the vin. If it was I I would do that with a header looking for help...
See more

Latest posts

Staff online

Members online

Total: 1,765 (members: 32, guests: 1,733)

Forum statistics

Threads
53,568
Posts
502,066
Members
47,123
Latest member
bronco_jimmy

Share this page

Top