I searched and was surprised not to find anything on this. Has anyone looked into taking the power liftgate components off a 2003+ Navigator and putting them on a Gen 2 Expy ? Anyone have a breakdown of what the components are ?
update: the shop replaced the condenser and ac is ice cold now, i have to turn the fans lower it gets that cold . the old condenser was little dirty externally but not bad looking at all, and it was not leaking . They blew through the old and new condensers and the old one had flow but not...
When I bought the truck last week the previous owner said he recently replaced the fan clutch. The new fan clutch he put on was roaring 100% of the time so I replaced his korean autozone fan clutch with a hayden (made in good old usa) . That cured the roaring all the time problem but there was...
My new to me 2003 had a known ac problem when I bought it.
Symptom: air is only cold on highway (the opposite of the 2003-2004 tsb)
ac low side pressure high, and high side pressure low with rapidly fluctuating pressure changes
Actions:
Replace fan clutch. no improvement
try...
i got the resistors last week and the ebay sub assembly finally arrived today
question - how do i wire this so it isn't on all the time ? the factory sub only has a power and ground so where does the aftm hu blue wire for turning on the amp go ?
I'm putting a stock sub and amp in an exp that did not have one originally. Does someone have the wiring diagram for the harness that connects to the sub box? End goal is to my aftm head unit that has sub out run the ford amp and sub.
My cruise doesn't work and I want to fix it before a long road trip coming up. Could someone post a wiring diagram or tell me the colors of the steering wheel switch cruise wiring?
My 98 failed on the self test, I get nothing at all so I want to start with the on/off switch with this test...
my cruise does not work in the 98 i just bought, ran the test and i don't get anything , is there supposed to be a light on the cluster that turns on ? are there any fuses that are only for cruise? all other systems/accessories work fine
i'd never seen my scangauge display those 2 weird codes before , i will check/replace that elbow and clean the maf tomorrow , discon the battery for a bit , and see what happens , thanks for the info !
The 98 I just bought has a new problem. Most of the time when warmed up it is idling around 1500-2000 rpms. The truck runs and drives normally otherwise, no detectable misfire , rough running, or trans issues. If someone could point me at what to look at it would be great.
My scangauge...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.