Recent content by Walt460

  1. W

    2011 with sync, clock disappeared and can not reset it.

    Vehicle has 3 separate small antenna wires. The lock on the connectors can be easily damaged such that the connector does not always stay in-place when the radio is being reinstalled. That is what happened to mine. Removed radio, again install the GPS antenna wire, and all is good again.
  2. W

    2011 with sync, clock disappeared and can not reset it.

    What the heck? I pull sync nav radio to replace that dang blend door actuator, now clock display is just --- --- I use menu to get to clock, but it will not respond to attempts to set it. What?
  3. W

    Blend door "clicking" still after changing acturator

    Yes it is a motorcraft actuator and yes we bench tested it and it worked great.
  4. W

    Blend door "clicking" still after changing acturator

    What happens if I just unplug the actuator that is behnd the radio? Iknow the blend dooor will stay in whatever place it was last, but will the rest of the automatic clmate system work or will it default to some useless mode?
  5. W

    Blend door "clicking" still after changing acturator

    The blend door turns nice and smooth with my fingers using the drive steam from the old actuator.
  6. W

    Blend door "clicking" still after changing acturator

    Yes it has dual zone automatic climate. I changed the one behind the radio. That is the one that was making the noise and that is the one that is continuing to make noise.
  7. W

    Blend door "clicking" still after changing acturator

    Front
  8. W

    Blend door "clicking" still after changing acturator

    OK, I do have the old actuator and I will take out the drive shaft and try using it to move the blend door. Thanks
  9. W

    Clicking sound from behind the dash

    So mine is the blend door and replacing the actuator has not fixed the problem. So now what do I do to stop the "clicking" sound?
  10. W

    Blend door "clicking" still after changing acturator

    OK, the blend door started "clicking" again after I changed the actuator 2 years ago. So, I bought another new acutator and installed it this morning. But, the "clicking" still occurs! What else causes this noise? If I put my hand on the new actuator I can feel the vibration when the...
  11. W

    2011 XLT after 100K miles

    "Sounds like you ought to buy a brand new vehicle every 4 years. No offense intended, you did request comments. 2003 XLT 4X4 & 2014 EL 4X4 Krown Oil + Fluid Fil" No offense taken MrSticker, and thanks for your comments. My Expedition is a great tow vehicle and I am just trying to keep it...
  12. W

    2011 XLT after 100K miles

    So my 2011 XLT with the 5.4L 6-speed and 9200# towing has gotten to 103K miles. I use it for towing my JimGlow car trailer and project vehicles, often on multi-day trips so reliablity is very important. So now I am wondering how long some components will last. I am planning to do radiator...
  13. W

    New from SW Illinois

    Welcome! Lots of great information and advise available on this site.
  14. W

    2015 Ford Expedition Power Heated Puddle Light Memory Turn Signal Blind Spot Detection Telescoping T

    So..... can these be retro-fitted to a 2011 Expedition? I mean will they bolt on and fit correctly? I can see my way to make the electrical connections but I suspect they must require a sensor somewhere to make the blind spot detection work, correct?
  15. W

    What to look for when buying a gen3 expy

    Snag, The 3.5L Eco has been in the F150 since 2011, and some issues were addressed in a 2013 revision and even more for 2015. So the 2015-up Expeditions "should" have a solid powertrain with the 3.5L Eco and 6R80.
See more

Latest posts

Members online

Total: 1,071 (members: 1, guests: 1,070)

Forum statistics

Threads
53,588
Posts
502,234
Members
47,171
Latest member
sharprd65

Share this page

Top