Need help asap!

Not that I know of. After you blow water out of plug/ pins, you can put some dielectric grease around outside of plug. You don't want to put it on pins, as it cuts down on electrical conductivity. Their probably is something that can be put on pins itself, guys what do you reccomend?


Sent from my iPhone using Tapatalk

Well I'm probably gone hear a conflict on this statement. But I just read online from a electronics engineer that worked both with television/ electronics, as well as automotive. His claim was he and his colleagues used silicone dielectric grease on the pin connectors that transfer current. Like the ones on your plug that connects to the Gem module. He stated that it not only transferred current on all the RCA and other brands TVs. It also worked fine in Automotive use. Be sure it is Silicone dielectric grease that you use. Not saying all water would be sealed out, but it's better than putting two bare plugs together, and getting moisture in there. Well theirs my two cents worth. As I always say, it works for me. Do with this information as you wish. Seal your windshield well. It's gonna be a wet weekend here in the Bay Area, and all the west coast.


Sent from my iPhone using Tapatalk

Well motor is fixed. Total of 4 injectors were bad. Then the speedo didn't work shifted hard. Found out vss wasn't plugged in. Plugged it in now speedo works. Shifts smothe. And cruise works. All fixed now.

I also added heated mirrors.

Now I want to add an ohc. With mpg. Trip. Temp. How hard is it. I want to ask here before starting a new thread

Good to hear you got it running right.


Sent from my iPhone using Tapatalk

Helll. I'm amazed I did. 4 bad injectors. 3 bad cats. Exhaust leak at both manifolds. 3 bad cops. Ancient plugs.

Somebody didn't know how to take care of there truck

New problem....

Was driving last night only about a mile away. suddenly lost all power.

Poped hood to check cables...in the dark....pos burned me. it got hot enough to melt the led clamp.

The negative melted the end off the cable. had to use a piece of rubber hose wo hold the wire to battery.....

Any ideas