Search results

  1. M

    Help my mpg is an 8 mile drag

    5.4's are thirsty. Also, if you had the original tow package, then you may have the the low gear ratio back end differential, which costs quite a bit of gas (but gives you more torque). (Most F150's have the 3.73 gear non-LSD. Most 4x2 Expy have the 3.73 non-LSD.) But a 4x4 with tow has...
  2. M

    03 expedition forscan help

    EX works well with Gen1 Expy's (1999-2002), and less well with 1997/8 Gen1's. With Gen2 Expeditions (such as yours, e.g. 2003-2006) Ford very much changed the communication networks. Gen1's used low and MS (Middle Speed) CAN, and that allowed OBDII, IC, PCM, ABS, GEM to be read...
  3. M

    1999 Expy 5.4L v8 throwing multiple codes, help please!!

    For your codes: P1400 DPFE Circuit Low Input P0174 System Too Lean (Bank 2) P0303 Cylinder #3 Misfire P0307 Cylinder #7 Misfire P0308 Cylinder #8 Misfire P0171 System To Lean (Bank 1) or P0113 Intake Air Temperature Sensor 1 Circuit Low For these codes: P0303 Cylinder #3 Misfire P0307 Cylinder...
  4. M

    1998 Eddie Bauer with codes...Where do I start??

    If you are going to do all that, then I would recommend spending another $60 (Amazon), and putting in a new DPFE valve in the engine compartment, downstream of the EGR valve. If that is operating poorly (but not technically failed) it can cost 2MPG. The code tests for that valve are not very...
  5. M

    1998 Eddie Bauer with codes...Where do I start??

    @Hoseman I hate to be the voice of pessimism on your fuel milage. (The EVAP,, good luck, that's solvable if you stay on it.) But 12MPG for the 97-2001 2V engines is in the window. (Mine has always gotten terrible milage, since brand new.) About 11.5 city, and 13.5-14.5 freeway. I have the...
  6. M

    Misfire in #8 cyl

    JamaicaJoe's suggestion to swap the fuel injector is good one, but I would do that second. I also would not bother with the spark test, it will not tell you anything. You are getting spark! If you were not getting spark (and had a dead cylinder), the 5.4L and the 4.6L will both run VERY...
  7. M

    Evap System Mon

    If you have hard codes, then you generally need to put on a OBD-II, and clear them. Of course, when you do that, then all of the emissions state is automatically cleared. e.g., clear any fault code, and all emissions state is set to incomplete monitors. That is CA and Fed. law, so all the...
  8. M

    Evap System Mon

    I really hate the Evap Test. Everyone does.... Its designed to approximate "real" driving, but NO ONE in California drives this way. The only people driving 55MPH (I know, I am there with them when running this program) are the illegal aliens who do not want to get pulled over for any...
  9. M

    Evap System Mon

    One more "rule" that I forget to mention, that is definitely a "rule" (I just forgot because I always use a fixed course at my house that follows this rule, and don't think about it.) For the FREEWAY part, the chunk of freeway has to be as FLAT as you can find. The 55MPH-59MPH is supposed...
  10. M

    Evap System Mon

    School of hard knocks. I have a '99 Expedition, 208K on it, in CA, has to get smogged every two years. However, the basics of it are actually described in the '99 Expedition User's Manual (not the Service Manual), in the Emission Controls sub-section, in Maintenance Section. The manual...
  11. M

    2005 Expedition P1450 EVAP leak

    Much less often.... Wiring problem is preventing the purge valve from being powered. (When it happens, 80% of the time its a bad ground, find the nearest ground straps, pull the bolt sand, remount bolt/strap, repeat. The other 20% of the time, the wire between the ECM and purge valve has a...
  12. M

    2005 Expedition P1450 EVAP leak

    Assuming that replacing the Evap Purge Valve doesn't/Didn't help and/or the canister. You need to check all of the interconnection hoses between the canister, the purge control valve, and the gas tank. 1450 usually means "too much" vacuum, meaning the vacuum is not bleeding off fast enough...
  13. M

    Evap System Mon

    How to Get the EVAP Monitor to Complete: 1. Get you gas tank at 1/2 fuel level. Cannot be more the 3/4, nor less than 1/4. Having it at 1/2 is safest. So, if you tank is all topped off, you will have to wait until you have used up some gas (don't waste it.) If you go empty, just fill it to...
  14. M

    Catalytic converter questions

    The 4.6L engine cats DO NOT interoperate with the 5.4L cats, they lookup with different part numbers,, and the two engines, exhuast manifolds, and hence exhaust system including cat demensions has different measurements. The 1998 Econoline 5.4L catalytic converters will work if they are the...
  15. M

    Head gasket

    I would say for the average home mechanic, its a crap ton of work. To do the job you must: 1. Remove the Timing Chain Cover 1a. Remove the Power steering pump (access is tricky and slow, but not hard). 1b. Remove the fan/AC belt. 1c. Remove the Fan assembly (to make room to...
  16. M

    Need ideas on how fix this so coolant stops leaking

    Pretty sure that the only interaction of coolant in that setup is at the fixture. Two coolant lines (one in, one out), and two vacuum lines (one in, one out). The coolant doesn't ever transfer to the vacuum lines. The fixture actually the PCV checkball flow. (NOT the PCV valve at the vavle...
  17. M

    2004 shakes violently when braking

    Or just drive it over to OReilly Auto or Autozone or NAPA and ask them to read the code on it for you. That's free, except the time.
  18. M

    2004 shakes violently when braking

    This one has LIVE DATA - Code Reader This other unit from Innova ($100) has live data. Obviously, a billion choices out there, I usually go for the Autel brand, they have been around a long time and I have had good luck with them. But to each his own preference.
  19. M

    2004 shakes violently when braking

    If the ABS light is on, then its probably that. Coder Reader with ABS, $49 Code Reader (click link to left). Is cheap, has ABS. Personally, I'd get one with ive data as well, and spend a little more, like $80. But $49 is not bad for ABS codes.
  20. M

    2004 shakes violently when braking

    First guess, its a warped rotor. But if its shaking badly, you ought to be able to see such warping. (Have you pulled both the front tires and actually inspected the rotors on both sides?) But after that: Shot steering linkage and stabilizer linkages in the front, or the control arm...
  21. M

    Where do you jack up your Expedition?

    @Trailmaster. The "T-Bar" (my slang) is the accessory jack replacement crossbeam saddle available on many a jack, from many a vendor. Amazon sells them, as do most racing supply stores (search jack crossbeam). I just found a great deal on a American, Foundry and Furnace (AFF, USA made)...
  22. M

    Where do you jack up your Expedition?

    People have been jacking on the diff housing for ages, and they have been doing it "wrong", "lazy", "easy", "simple" for ages that way too. It is a "lawyers" sentence, but not only because of the safety in jacking. (It is considered sufficiently safe to jack any vehicle with two tires down...
  23. M

    Interesting and stupefying heater question.

    Blisto is correct. The 1st Gen's (97-2002) do not have the heater control valve. They are full time flow on the front core, as well as the back core. But the '03 and later have the front control valve. So the original poster (who did not specify his model year) could have either a frozen...
  24. M

    Interesting and stupefying heater question.

    Usually one of three common problems on these older models. 1. Heater core is totally clogged. 2. Blend Door base has broken 3. Blend Door Servo has failed ---- That presumes that air is blowing, e.g. that you do not have an issue with the blower. (If the blower, almost always the blower...
  25. M

    Windshield wipers acting up

    From your description ( a little vague) it could be any of these things: 1. Multifunction switch in the steering column (e.g. the left stalk). [But probably is NOT the switch.] 2. The GEM (General Purpose Electronics Module) that takes input from the Multi-function Switch. 3. The rear wiper...
Top