Search results
-
S
How to Manually get the Transmission into 6th gear under 40mph
Thanks Moose for the reply. This engine and 6 speed trans work together very smooth. I don't think the 6th gear gives any more top ratio than your 4; just fills in the spaces in between. I am sure that it was designed to get past the EPA standards and mpg usage cops. At 38 mph and light...- skywagon
- Post #3
- Forum: Transmission & Drive train
-
S
How to Manually get the Transmission into 6th gear under 40mph
My Expedition is a 2014 and I really like the car as well as the 2005 that I had. But there are times, I want to get it into high gear early. Mine, like most, with light throttle will shift into high at about 40mph. I live in a town that is basically flat and with most speeds of 35mph. If I am...- skywagon
- Thread
- Replies: 5
- Forum: Transmission & Drive train
-
S
Cylinder 1 Misfire. NOT plug,coil,or injector. Help
I don't think you mentioned changing out the ignition/spark cable to #1. Age, exhaust heat, and moisture are hard on the spark cables. DL- skywagon
- Post #11
- Forum: 2nd Gen - 2003 - 2006
-
S
2014 Drivers Seat switch "panel" breaks and fixed. . . .
My 2014 EL model has 4 switches on the drivers seat controls shroud/panel. A plastic molding piece wrapped around the seat, left side. That panel plastic snap-to-hold pieces broke and was hanging partly loose. This piece is very likely to be broken at some time due to sliding ones butt into...- skywagon
- Thread
- Replies: 6
- Forum: 3rd Gen - 2007 - 2017
-
S
Popping Noise From Rear A/C Blower '03 Expo
Steps to Removing the Side Panel. . . Gulfman. . again, thanks for that by-the-step link to pulling that side panel. I have 2 additions that I would add to that procedure for future forum readers. 1. On step #4, there is also a plasic button above the seat belt attach point and must be...- skywagon
- Post #151
- Forum: 2nd Gen - 2003 - 2006
-
S
Popping Noise From Rear A/C Blower '03 Expo
Thanks GuilfMan for the web link to this Ford site. The details are very clear. It is a shame that Ford designs made this simple repair envolve so many steps get to the actuator. These actuators look very mickey mouse using plastic gears in the primary gear set. Would be a terrific option if...- skywagon
- Post #148
- Forum: 2nd Gen - 2003 - 2006
-
S
Popping Noise From Rear A/C Blower '03 Expo
Details for popping off the side panel. . . The removal of the side panel "in 5 minutes" sounds great. . !! I have not had that panel off before. Thus, I don't know where to effectively start. Where the screws are to remove and where to press on the molded in snaps that probably have to be...- skywagon
- Post #146
- Forum: 2nd Gen - 2003 - 2006
-
S
Popping Noise From Rear A/C Blower '03 Expo
Getting at the lower air blend actuator Thanks to all for the many details. . . My 2003XLT has the lower, hot/cold, actuator with stripped gears. With the tray & drink holder popped out, they can both be viewed.. What I need is the specific details on what to pop loose/unscrew to get the side...- skywagon
- Post #144
- Forum: 2nd Gen - 2003 - 2006
