Search results
-
3rd gen 5.4L issues
On a cold start, I have a normal crank and the engine starts right up. On a warm start, the crank continues for 1-2s after the engine starts up. I have also noticed my long fuel trims creeping up. While idling or very low throttle, they're as they always were. Give it some gas and they run...- ManUpOrShutUp
- Thread
- Replies: 1
- Forum: Engine & Performance
-
Pennzoil rebate ... Grab some oil while you can
$25 rebate on 10 quarts of full synthetic. Must buy all 10 in 1 order. It doesn't specify what type of giftcard the rebate will come in the form of, but in the past it has been a Shell giftcard. List of eligible retailers on the rebate page. Amazon and Walmart are both on there...- ManUpOrShutUp
- Thread
- Replies: 9
- Forum: General Discussion
-
Ford Expedition vehicle partition 2003-2006
Pro-Gard 4PS04PG Vehicle Partitions with Sliding Plexiglass. Includes 2 partitions: (1) standard partition to separate front-rear seats (2) cargo partition. Fits Ford Expedition (This was pulled from a 2006 Ford Expedition Police Interceptor, so it should fit 2003-2006 no problem. May fit...- ManUpOrShutUp
- Thread
- Replies: 2
- Forum: For Sale
-
Oil analysis over 2 years and 41k miles
My latest report was good overall, but the iron and magnesium values have shot up considerably. 150,348 mi. 9/15/2019 191,689 mi. 8/2/2021- ManUpOrShutUp
- Thread
- Replies: 2
- Forum: 3rd Gen - 2007 - 2017
-
Oil filter adapter gasket ... anyone done this on 4WD?
While I had my truck apart to do a tstat today, I figured it was time to finally do the oil filter adapter gasket. In theory, this is an easy job. With a front differential though, I am finding it incredibly difficult to get a grip on the lower radiator hose clamp and the engine oil pressure...- ManUpOrShutUp
- Thread
- Replies: 9
- Forum: 3rd Gen - 2007 - 2017
-
My 5.4L saga ...
Long read ahead. Scroll to the bottom for the TDLR version. At around 155k miles I started noticing that I was needed to add oil more and more often, especially after long trips. Mechanic looked at it and insisted I was burning it (despite the visible errant drops of oil at the bottom of the...- ManUpOrShutUp
- Thread
- Replies: 36
- Forum: 3rd Gen - 2007 - 2017
-
150K oil report
As above. Conventional oil. Looking good.- ManUpOrShutUp
- Thread
- Replies: 14
- Forum: 3rd Gen - 2007 - 2017
-
Sunroof repair
I very, very rarely use my sunroof, but tonight I did so and was swiftly punished for the decision. The sunroof opened, but I could hear something crack as it did so. It then got stuck open very shortly before we had a torrential downpour. Fun times. Anyway ... The motor is still...- ManUpOrShutUp
- Thread
- Replies: 48
- Forum: 3rd Gen - 2007 - 2017
-
fuel injector wiring (2011 Expy)
I spent the last couple days trying to find the source of my P0201/P0301 TCs and had no luck. Tonight I had a buddy here so I decided to repeat some of the tests with him at the wheel while I tested various plugs. When I did this, I found that the noid light went on and off when I bent the...- ManUpOrShutUp
- Thread
- Replies: 4
- Forum: Electrical
-
Anyone have the WeatherTech 43222 mat?
Anyone have the WeatherTech 43222 mat? It's listed as only being for the standard length, but that doesn't really make any sense. I contacted WT for the measurements, but apparently they don't actually manufacture them nor do they have access to them, so they said it would be several days...- ManUpOrShutUp
- Thread
- Replies: 1
- Forum: Interior
-
Heat shield part # ?
* Sorted. Please delete.- ManUpOrShutUp
- Thread
- Replies: 0
- Forum: 3rd Gen - 2007 - 2017
-
Non-matching struts?
In January 2016 I had the right rear strut replaced on my '11 EL under the extended warranty. The dealer wouldn't approve replacement of the other and I wasn't about to pay them the $850 they wanted to do it. Here I am about 10K miles later and the left rear strut is shot. Normally, I would...- ManUpOrShutUp
- Thread
- Replies: 7
- Forum: Suspension
-
Has anyone done an HID retrofit w/ Anzo headlights?
Has anyone done an HID retrofit w/ Anzo headlights on a 3rd gen? I'm talking about a real retrofit with projectors. I was considering buying a set along with some Morimoto projectors, but since I don't have them in hand I don't know what size projectors will fit without cutting (e.g. Mini H1...- ManUpOrShutUp
- Thread
- Replies: 6
- Forum: 3rd Gen - 2007 - 2017
-
Keep fogs on with high beams ?
I know this has been asked before (here and elsewhere), but it seems no one had an answer for the 3rd gens ('11 in this case). I've got the wiring diagrams, but my knowledge in this area is a 1/10. Can anyone direct me on how to get my fogs to stay on when I switch to high beams? (or let me...- ManUpOrShutUp
- Thread
- Replies: 11
- Forum: Electrical
