71Rcode's latest activity
-
I debated the oil pan. It' not in my bio, but the truck has 80k on a Jasper engine. seems like every gasket is weeping. Might as... -
I left everything on the valvetrain untouched and intact, I used a pair of vice grips on the rough casting part to hold the cams in...
-
71Rcode reacted to Trainmaster's post in the thread Will my brake rotors need to be replaced at 60k? with
Like.
I drive an 08 in suburban New York traffic and generally get about 60K miles from a set of Motorcraft brake pads. At that mileage, my... -
71Rcode replied to the thread Will my brake rotors need to be replaced at 60k?.Do you feel any pulsation in your pedal when stopping? Is that the first 60,000 miles of the vehicle with OEM rotors? Or is that an...
-
71Rcode replied to the thread Wheel Noise.Is it a 4x4?
-
Just a heads up with others reading this thread, my front blower motor quit working on me, but rear was fine so I used that until our...
-
Update on this problem. I bought the wiring diagram book (about $30 used) and studied the components in the circuit. There actually...
-
71Rcode replied to the thread How to stop upper control arm from hitting springs after a lift.Which manufacturer kit did you use? I used a very basic kit from a rough country to bring it up a couple inches. The suspension seems...
-
71Rcode reacted to chickenator's post in the thread My experience and symptoms of both front brake hoses going bad. with Like.
My 2014 had been acting not quite right but not really wrong enough. Keep in mind I can do some advanced mechanical work. Like building...
-
My wife's '08 Expedition has just over 330,000 miles on it and it's been pretty good to us. Some common items have been replaced, like...
-
71Rcode replied to the thread Power Stop drilled and slotted full kit with calipers.I've used their non slotted rotor kit. Very happy.
-
71Rcode replied to the thread Dreaded Humming from Front end.Nice job man. You replaced the hubs assembly I presume?
-
71Rcode replied to the thread Dreaded Humming from Front end.My buddy farmed out the replacement of the Hub the iwe and the axle CV to an independent shop. I think they used all Dorman parts. I...
-
71Rcode replied to the thread Dreaded Humming from Front end.Does the noise go away in AWD mode? Mine did. Hubs first followed by IWEs. IWEs were the root cause. Not a difficult DIY job for either.
