Recent content by Aggiesrok

  1. Aggiesrok

    2012 w 150k on it. Engine or Transmission Sputtering around 45-55 uphill under load?

    My vehicle had 150k plus miles. Threw a code for a coil and then threw a code for another coil after replacing the other. It was cheaper to buy a whole set of coils than 2 or 3 and keep replacing. I replaced them all and the plugs and have had no problems since. I’m in Texas and the heat does...
  2. Aggiesrok

    2012 w 150k on it. Engine or Transmission Sputtering around 45-55 uphill under load?

    My point was they start going out near 150k, especially the ones near the firewall, just like the F150’s. Sent from my iPhone using Tapatalk
  3. Aggiesrok

    2012 w 150k on it. Engine or Transmission Sputtering around 45-55 uphill under load?

    At 150k coils are a wear item. Sent from my iPhone using Tapatalk
  4. Aggiesrok

    2012 w 150k on it. Engine or Transmission Sputtering around 45-55 uphill under load?

    There was a recall on transmission for that year, it’s a reprogram. It had some issues of bogging. I had a 2012 with 156k. I replaced all the coil packs, buying 8 is cheaper than buying 3 or 4. It made a difference and an easy replacement. Should change the plugs at the same time. Sent from...
  5. Aggiesrok

    Sunroof won't close

    I had the same problem. The plastic track breaks and jams. Mine was closing at an angle, only one track was broken. I was able to push the glass closed with my hand as I held down the button. When the motor is trying to close it and it gets resistance, the motor surges and reverses. If you can...
  6. Aggiesrok

    2011 Expedition Blend Door Actuator location

    I replaced my drivers side on my 2012 limited. I removed the panel below the steering wheel and the pedal assembly from the firewall. I was able to access the blend door actuator fairly easily. Depending on which AC system you have it may be in a different location. Sent from my iPad using...
  7. Aggiesrok

    Help ... What is this Cable???

    Which cable? You’re not talking about the white padding (side air bags)? What are you doing that it takes up too much room? Sent from my iPhone using Tapatalk
  8. Aggiesrok

    Michelin LTX 265/70/18 E rated option - would you buy?

    Look at the load rating for the tires compared to oem. Sent from my iPhone using Tapatalk
  9. Aggiesrok

    Help finding fuel pressure sensor

    Could be trans related, lots of things will retard the engine. There was a recall in mid 3rd gen trans for a software update to fix the car stumbling on acceleration and didn’t throw a code. Sounds like the engine is in good shape. Sent from my iPhone using Tapatalk
  10. Aggiesrok

    P0172 and P0175 on 2014 Limited

    Here’s a possible cause, read this: https://ricksfreeautorepairadvice.com/ford-p0172-p0175/ Sent from my iPhone using Tapatalk
  11. Aggiesrok

    2015 EXPED XLT

    Side note. Is your daughter attending UNT? Edit: my daughter does. Go mean green Sent from my iPhone using Tapatalk
  12. Aggiesrok

    2015 EXPED XLT

    If jiggling it made it work then it’s either a broken wire or the bulb socket has a loose connection in it. I would check the the socket carefully and look for bad wires. If nothing is obvious you’ll need to get a multi tester and figure out which wire is the culprit. Sent from my iPhone...
  13. Aggiesrok

    Miss when taking foot off accelerator?

    If you do change your plugs, just order the extractor tool from Lisle. It’s about $75. If one breaks you can fix it. Hopefully someone changed them by now. Sent from my iPhone using Tapatalk
  14. Aggiesrok

    Defrost Blender Actuator 2012

    I found those, a bit over simplified considering how much more I had to remove in order to get the actuator out. Sent from my iPhone using Tapatalk
  15. Aggiesrok

    Defrost Blender Actuator 2012

    Ok update... I removed the 3 bolts for the accelerator assy with no problems. I left all the wires connected and was able to push it out of the way and fairly easily remove the actuator. FYI if you’re doing this yourself when you install the new actuator, if the shaft doesn’t line up, you can...
See more

Latest posts

Members online

Total: 1,642 (members: 20, guests: 1,622)

Forum statistics

Threads
53,537
Posts
501,804
Members
47,065
Latest member
enn_gee

Share this page

Top