Recent content by Alwhite00

  1. A

    Painted my lower bumpers black

  2. A

    Painted my lower bumpers black

    I have a silver expedition and the lower bumper being silver on the expedition it was just a lot of silver.
  3. A

    Any tips for first time DIY oil change on 2020 Expedition 3.5?

    Isn't that 6" high? Commercially available 2x lumber is 1.5" I'm looking into building a set.
  4. A

    Do you need to remove seat to replace bottom upholstery?

    Yea, I got it figured out, I took the seat out, got er fixed up and a new cover installed. Thank you
  5. A

    Got around to rebuilding my seat.

    Seat rebuild went well. Apparently a heavy hitter owned this. There was broken clips, frame pushed through the foam on the outer bolster, bolster disintegrating and a split in the side of the cover. I glued the split together, added material to get the bolster back to the correct height...
  6. A

    Well, i did my phasers.

    Two post lift, an absolute back saver on this job.
  7. A

    Transmission Service

    Why replace and not flush? I'm looking at doing mine. Just curious.
  8. A

    Well, i did my phasers.

    I guess the lift isn't "needed" but it definitely makes this job much more bearable. I myself would no attempt to do this on the ground, I'm not 20 anymore.
  9. A

    Do you need to remove seat to replace bottom upholstery?

    Is the F150 foam the same? (What trim) I don't see the expedition listed. Edit: It looks like heated/cooled seats are special and extremely expensive.
  10. A

    Do you need to remove seat to replace bottom upholstery?

    Ordered a replacement driver bottom seat upholstery and wanted to verify if the seat needs to come out, I'm guessing that it does but wanted to check. Anything to look out for? TIA
  11. A

    Well, i did my phasers.

    2018 - 97,000 miles.
  12. A

    Well, i did my phasers.

    Have to take just a few parts off
  13. A

    Well, i did my phasers.

    All I can say is I'm glad that over and I had the use of my buddy's lift. That was a back saver. Took me about 15 hours. No more rattle.
  14. A

    New here, phaser question.

    Disconnect sensor before starting the work or for some other reason?
  15. A

    New here, phaser question.

    Just picked up a 2018 Expedition Limited, 97k. Slight rattle on startup. Nothing on the carfax saying the phasers were replaced. I’m looking at eventually replacing them but would like to do chains, tensioners, guides and whatever else is needed. Water pump? Oil pump? I’m looking for either a...
See more

Latest posts

Members online

Total: 3,058 (members: 6, guests: 3,052)

Forum statistics

Threads
57,616
Posts
536,356
Members
54,665
Latest member
fordseller

Share this page

Top