Recent content by Cthunndr

  1. C

    Brand New Wheel hubs bad?

    To those who commented today, Were you guys able to look at the video and hear the noise?
  2. C

    Brand New Wheel hubs bad?

    I guess that will be the next step.
  3. C

    Brand New Wheel hubs bad?

    I hear ya in regards to “F. E. T. P’s” lol. The first replacement was a duralast hub, the second was from Napa...forgot the brand, and the third I took a chance on from a junked donor truck. Since I have the extra hub I could always throw that on the right and see if there’s a difference. I...
  4. C

    Brand New Wheel hubs bad?

    Any idea where to look next? Even if it isn’t the bearing per se, it sounds and feels like a bad bearing issue.
  5. C

    Brand New Wheel hubs bad?

    Has anyone have them Go bad like that?
  6. C

    Cruise control

    I had a similar problem with mine. I replaced that same switch. It goes under the dash at the top of the brake pedal arm. Didn’t fix my cruise control turning on. I ended up swapping the cruise control switch on the steering wheel with on from a junkyard and it worked. A small tip screwdriver...
  7. C

    Brand New Wheel hubs bad?

    Update - I noticed my upper and lower ball joints were bad so I replaced them and still have the vibration. I even went as far as swapping the left side cv joint and wheel hub from another ex and still have the same noise/vibration. Starting out at slow speeds it’s a hum that gradually turns...
  8. C

    Brand New Wheel hubs bad?

    Wasn’t tie rod. There was no movement when shaking the wheel left to right. It only moved when I shook it up and down. When driving I get hear the noise a bad bearing would make along with vibration in the steering wheel
  9. C

    Brand New Wheel hubs bad?

    The original hub bearing went bad. I replaced it with a new hub assembly. When putting the nut back on the half shaft, I over torqued it causing the stud to snap off the end which is why I bought a new half shaft. The first replacement hub it was bad right off the start. I then Took it back to...
  10. C

    Brand New Wheel hubs bad?

    Greetings. I have a 2007 EL 4wd. I recently had the left front wheel bearing go bad. I went to autozone and bought a new one. I installed it and after taking it for a spin the noise occurred with the new hub. I took the new hub off and went back to autozone at which point they exchanged it...
Top