Recent content by devadip
-
D
Engine missing after replacing intake
A compression test would be worth doing. It could be possible that something fell in the cylinder while changing the intake mainifold. If compression is good, I would start by testing injectors to see if they are operating correctly by holding a steathscope up to them and hear that...- devadip
- Post #5
- Forum: 1st Gen - 1997 - 2002
-
D
Window popping out of rubber
Thanks for posting this. It was on my list to fix this spring. It is one of my pet peeves of my truck. When someone else drives it and lowers the window, they do not grab the window when it goes up to and the window pops out of the track. I will try the lubrication trick.- devadip
- Post #9
- Forum: 1st Gen - 1997 - 2002
-
D
Broken Sensor 5.4 ID?
Took it down to advance auto and it was the cylinder head senor. $24 and I have a new one.- devadip
- Post #5
- Forum: 1st Gen - 1997 - 2002
-
D
Broken Sensor 5.4 ID?
Hi, I am in the middle of the replacing the intake manifold on my 5.4 engine. While doing that I am also replacing the valve cover gaskets. The passenger side was quite frustrating. While doing this I stepped on a sensor in the middle of the motor and broke the top off. Is this the...- devadip
- Thread
- Replies: 5
- Forum: 1st Gen - 1997 - 2002
-
D
How To Change Rear Diff Fluid
I used Mobil 1 and added the Motorcraft friction modifiier. I aslo used a Felco gasket. The gasket was only $7 and I got rid of the wait time.- devadip
- Post #21
- Forum: How To Section
-
D
What type and brand of torque wrench do you recommend?
I have had old Craftsman beam type and Harbor Freight clickers. The Harbor Freight was very hard to read. I know have a range of Tekton clickers. They come with a nice case and much easier to read. -
D
Question about seat repair
Any chance that you could post more pictures of the seat apart. This is on my too do list over the winter.
