Recent content by InocentRoadkill
-
I
2nd gen lower cladding for sale
Do you still have the drivers rear small piece right before the wheel. It's like 4 inches wide. Or if you don't want to split them up can you tell me where to get that one.- InocentRoadkill
- Post #6
- Forum: For Sale
-
I
Rattling Noise from Driver-Side Door
I tried to move the striker a bit but it didn't seem to work. So I did some closer inspection and it looks like the rubber in the door is meant to hold the striker snug to the latch. When it gets old it rips and then you get the rattle. Plastidip may work but would get worn down just the same...- InocentRoadkill
- Post #19
- Forum: 2nd Gen Ford Expedition Exterior
-
I
Taurus E-Fan (Ford part # 8C607)
Has anyone tried to use the two speed 90-95 Taurus E-Fan on the gen 2? This is a popular mod on the ZJ Grand Cherokee's, wasn't sure if anyone has attempted it here. Link to GC mod write up I know it will not be a bolt on mod but I'd much rather have a two speed than the single speed ones...- InocentRoadkill
- Thread
- Replies: 0
- Forum: 2nd Gen Ford Expedition Engine & Performance
-
I
Rattling Noise from Driver-Side Door
'04 xls here. Same problem. The rubber behind the latch inside the door is ripped in a few spots. Looks like this is a common issue for these trucks. Electrical tape fixed it for now but I am looking for a lock rebuild or something to fix it for real.- InocentRoadkill
- Post #17
- Forum: 2nd Gen Ford Expedition Exterior
