I had a reoccurring door squeak on last f150.It ended up being the small rubber wind gasket at the base of the windshield "A" pillar..... A LITLE SILICONE SPRAY AND IT WOULD GO AWAY .. respray periodically and it will stay away
My 2022 flaked out on a trip up north in december. Drive mode and 4 wheel drive unavailable . Multiple times totally random. The little wrench appeared went away and came back. A couple of weird display issues also on 12 inch radio screen. Finally got it for service and they ended up replacing...
when was the last time the trailer brakes were adjusted out. They are not self adjusting and become less effective as they wear and the distance between the shoe and drums increases.....just a thought.....
added front auxiliary LED lamps to the front grille with the ford Aeroskin. I hope to add a larger LED down low when I can find a solid way to mount it. Last summer I added the rear work lamps to the rear.
angle brackets home made with stainless fasteners. Switch set from Oreilly's, relay mount home made. power wire runs across the top of firewall to power center positive and negative power studs. wiring from relay runs between air box and apron and out through existing hole to the grille area in...
bought lights on ebay for about 15.00 each . got a light relay switch wiring kit at menards for about 25.00. I made some small angle bracket to mount them to the plastic grille. I will take some pictures tomorrow.
Just installed these today... not fancy but a clean look with some extra light. I am anticipating adding a a lager LED down low and in the center in the future if I can find a user friendly way to mount it.
Just received the new weathertech rear mud flaps... No cam locks just mounts with four sheet metal screws into captive nuts installed where the plastic inner liner plugs are removed... see the pictures..... will be installing tomorrow I hope.
I have xlt base with HD tow package with 20 inch hankooks and the ride is terrible with recommended tire pressure of 39 psi. It is very rigid and the rear end tends to hop over bumps when empty. I run 34 to 35 tire pressure and it helps some. fully loaded and with some tongue weight the ride is...
Hello All. I am thinking of adding the Aero Skin to the leading edge of the hood. Has anyone done this for the generation 4 series? There are two different models what are the differences. Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.