So my rear drivers side spark plug blew out. im wondering is it worth buying a kit and taping all the plug holes or just have the one taped and helicoiled? and about how much does getting one plug repaired cost?
thanks
ray
https://kralautoparts.com/product/exhaust-manifold-bolt-repair-kit-kap5-4-single
my right rear exhaust manifold bolts have snapped, has anyone used this clamp kit?
i know very little about the SJB the main thing to remember is wherever you buy it from needs to have your Expy's VIN# to double check which SBJ you need
ok where to start.... power door locks stopped working. power windows stopped working. drivers rear turn signal stopped working. a no crank no start problem and it died because of the fuel pump relay going bad
this turn out to be a bad ignition switch. im sure the wires cut and spliced together didn't help.
i have also replaced the fuse box with the correct updated one. the expy is running great and is a mountain goat in snow
Hi, we are installing a few lightbars and some work lights on the EXPY and im looking for places to put the switches. i want to put a switch panel over the whole front cubby/change ash try area.
has anyone done this? what panel did you use? do you have any photos of switch panel installs...
after a month of work and family drama i can finally get back to the expy. began with charging the battery and seeing if it would start. same nothing happened. tried again and i bumped my knee on the trailer brake unit herd a clicks in the SJB and it started. only ran for 30 sec or so then...
yesterday when i back probed C270a pin 1 with my test light "didnt get power" shouldn't it have tried to start then? my light didn't light up but i do get a click from the starter relay every time i try to start it
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.