Recent content by Redwood
-
Lowering the front
That'll be it if you're wanting to add the same rake. I'm hoping a new set of rear coils will perk it back up in the rear though.- Redwood
- Post #11
- Forum: 1st Gen Ford Expedition Suspension
-
Lowering the front
Loosened the torsion bar bolts 4.5 turns. Got a good solid inch out of it. Looks a lot better, but still not quite where I want it. Originally went 6 turns but the ride/driveability became really soft and unpredictable. Still going to replace the rear coils in the near future.- Redwood
- Post #9
- Forum: 1st Gen Ford Expedition Suspension
-
'98 EB Sloppy Column Shifter
Same problem on mine. The two screws circled were tight. It was 2 screws further above that in the dash that were really loose. Tightened 'em up and that fixed it.... Thanks for the tip! Saved me a TON of hunting!- Redwood
- Post #16
- Forum: 1st Gen Ford Expedition Interior
-
Lowering the front
I think I'm going to lower it with the torsion bars and report back on how it does. In the mean time I'm going to price some coil spring spacers for the rear. I'd rather get it a little closer to the stock tires than away as I'm not going to be crawling. Hoping to pick up a half a mile to the...- Redwood
- Post #6
- Forum: 1st Gen Ford Expedition Suspension
-
Lowering the front
How bad will it affect ride and handling by lowering the stock bars?- Redwood
- Post #3
- Forum: 1st Gen Ford Expedition Suspension
-
Lowering the front
This may be backwards from standard thought or practice, but here goes. I've got an 02 4x4 EB Expy. The suspension to my knowledge is stock. The front sits higher than the rear. I'm not a fan of that look and am wanting to lower the front down just enough to give it a nice subtle rake. I don't...- Redwood
- Thread
- Replies: 10
- Forum: 1st Gen Ford Expedition Suspension
-
New member from MS
New member from Pelahatchie, MS here! Just traded an 02 Mountaineer 2wd for an 02 EB Expy 4wd. Love the site!- Redwood
- Thread
- Replies: 4
- Forum: New Member Check-In
