I use the fuel and oil as well as transmission products from Lucas in everything. Even my new JD tractor and Echo trimmer.
I brought two old Thunderbirds back to life as work cars with the stuff. Got years from both. My JD old tractor is a model 70 built in 1969!
I would love to see any other front and rear bumper options that might be possible... for future reference.
I will tell you that the rear FORD part bumper cover is now on back order thru most parts dealers. I found one in NY and took a road trip to get it for my 2012 EL Limited that has been it...
I just replaced my "T" fitting with a brass one from Lowes. Snipped off the plastic shrink clamps at the holes with wire cutters. Then with channel locks I squeezed the internals and cleaned out the hose ends with a shop vac. I did look into them with a light to be sure all the plastic was out...
Well, like Okgearhead said. Body shop guys know, try the bone yard, or... its a truck so I would put a self-tapping screw close to the hole and be fine with it. But try to find it thru shop guys.
I Always keep an eye on things and lube bushings as well. This was a total shock.. Ha I see that!... Never hit even a bad pothole. It looked to me that the design of the lower bushing some how went dry and locked up.
Then the normal travel just set in metal fatigue that eventually broke. They...
So to start, on the way to work I heard a terrible noise in the front of the truck and it goes down on the passenger side. The botttom of the Monroe quick strut snapped off and luckily was lodged into the lower control arm. These are lifetime warranty and they did come through with replacements...
Hello,
I fixed my panel by adding countersunk screws 2 years ago.
I just took my time to locate the steel behind the trim and went thru while I held the part in place. I then tapped the threads.
I did this because even with the new part acquired, you will most likely break again anyway. It’s not...
That is a “Browns gas generator” it makes HHO to be pulled into the engine vacuum. I had on on a 99 F-150 and got 25mpg at times. It will need To be maintain and cleaned if your going to try it. But that’s a homemade unit.
Works thru electrolytes releasing O and H H separately off an anode ( SS...
And now we drink it...
Ie...
Willow Grove Pa. Willow Grove Airport water contamination lawsuits against the US Navy.
Cancer everywhere in surrounding neighborhoods.
Looks fun till it’s not.
And all from years of training too....
Hello,
I fixed my panel by adding countersunk screws 2 years ago.
I just took my time to locate the steel behind the trim and went thru while I held the part in place. I then tapped the threads.
I did this because even with the new part acquired, you will most likely break again anyway. It’s...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.