You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Recent content by tjenkse
-
T
Help!! Can't remove the ignition lock cylinder.
I'm having a problem removing the ignition lock cylinder in my wife's '99 Expedition EB. The procedure is to turn the key to the run position and insert a small tool in the hole underneath the cylinder, depress the retaining pin and pull the cylinder out. When I depress the retaining pin, I...- tjenkse
- Thread
- Replies: 2
- Forum: 1st Gen Ford Expedition Interior
-
T
Replace steering column
Thanks to stamp11127 and F1vel66a for your helpful replies. I put off this job until the truck became undriveable. Turns out I didn't have to replace the whole column. There's 2 tilt-wheel pivot bolts on either side of the ignition lock cylinder housing, remove those and then take the housing...- tjenkse
- Post #4
- Forum: 1st Gen Ford Expedition Interior
-
T
Replace steering column
The steering wheel in my wife's 1999 Expedition is loose. Looks like the bearings in the upper steering column are shot so I need to replace the whole thing. I'll be playing this by ear, my book has no procecures for this. Anything I need to watch for? Also, when I put things back together, what...- tjenkse
- Thread
- Replies: 3
- Forum: 1st Gen Ford Expedition Interior
-
T
misfire diagnosis and repair
Check the PCV valve and hoses. In these Expys the hose has rubber elbows that can rot and leak causing the engine to run rough. Just an idea.- tjenkse
- Post #15
- Forum: 1st Gen Ford Expedition Engine & Performance
Latest posts
-
-
-
-
Recall: Center Console May Peel, Causing Sharp Edges
- Latest: 99WhiteC5Coupe