Recent content by Zap Rowsdower

  1. Z

    Windshield Wiper arm removal process

    That's awesome! I just did the needle through the hole in the sprayer nozzle while I'm here at the office. I'll use the sprayers when I'm driving on my way home to see if it worked. Don't want to get washer fluid on anybody else's car while its parked in the parking lot. If it didn't work...
  2. Z

    Windshield Wiper arm removal process

    I'll give the safety pin method a try. However, if I do need to go to the puller route that seem pretty intense just to remove wiper arms. I've seen the F-150 wiper arm removal and it has a latch holding it on. I was just hoping I missed something on the Expedition's wiper arms that would...
  3. Z

    Windshield Wiper arm removal process

    Hello Expedition community, I've noticed a problem with my windshield wiper fluid sprayers not spraying on the driver side of my windshield. I want to see if there is possibly a crack in the fluid line or if I just need to replace the sprayer itself. I did a search specifically on removing...
  4. Z

    MagnaFlow Cats

    I'm very interested in doing this upgrade myself. Did you notice any improvements in performance?
  5. Z

    Jack stand placement when doing brakes

    I'll give that a try, now what about the front end? I see the cross member underneath the engine block but am not sure you can lift the whole vehicle from that point.
  6. Z

    Jack stand placement when doing brakes

    I'll have to look under the vehicle again for these arrow cutouts. Do these points on the SUV make it to where it is not leaning almost to one side (what I was experiencing)? Thanks everyone for the comments.
  7. Z

    Jack stand placement when doing brakes

    I’d also like to point out that the owner’s manual doesn’t say where exactly jack up the vehicle. All it shows is an image of the Expedition and arrows where to jack it up at. I used that as a reference point to jack up the rear and I still didn’t feel comfortable once the vehicle was in the air.
  8. Z

    Jack stand placement when doing brakes

    This is a pretty lame question but when I jacked up the 04 the other day I had the most difficult time getting the rear passenger side high enough to get the tire off of the vehicle. When I was able to get it high enough it looked it the majority of the weight was on the driver side of the...
  9. Z

    Replacement Turn Signal Switch on 04 Expedition

    Yup, my rear driver side turn signal light is out. Man something so simple and I didn't bother to check :facepalm:
  10. Z

    Replacement Turn Signal Switch on 04 Expedition

    I haven't bothered to check the rear as I could see my front in the reflection of the car in front of me. I'll check the rear.
  11. Z

    Replacement Turn Signal Switch on 04 Expedition

    I noticed today that when I move my turn signal down for left turns it blinks double the speed of what it does when it is up for right hand turns. I switched on my Hazard lights and then switched them off but still not change on the left. I'm guessing it's my Turn Signal Switch. I've never...
  12. Z

    Magnaflow Direct Fit Catalytic Converters

    Thanks for the reply. Were they the direct fit catalytic converters? Did you go from a 2 cat to a 1 setup?
  13. Z

    Magnaflow Direct Fit Catalytic Converters

    Has anyone installed these Magnaflow Direct Fit Catalytic Converters: Part Number: 93126 Amazon.com: Magnaflow 93126 Direct Fit Catalytic Converter (Non CARB compliant): Automotive Part Number: 93125...
  14. Z

    Stainless Exhaust INSTALLED!!!

    You didn't have to cut the tail pipe right after it goes over the rear suspension? I see you used a cut off wheel to trim off the extra threads on the bolts, not sure if you used it on the stock exhaust to cut the tail pipe off. Lastly not including letting the PB Blaster set for 2 hours...
  15. Z

    Pads and Rotors Replacement

    Awesome! I'll check them out.
See more

Latest posts

Staff online

Members online

Total: 1,561 (members: 20, guests: 1,541)

Forum statistics

Threads
53,630
Posts
502,589
Members
47,237
Latest member
Michael485

Share this page

Top