OEM Raptor Wheels and Tires
- Thread starter MATT0404
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
AKentPhoto
Full Access Members
Well done! What spacers did you go with?
Rough Country .250.......and still had to sand down just a little of the inside of the cap the clear the axle....not even enough to show through the other side. A 3/8 or 7/16(or metric equivalent) might just be the ticket.
AKentPhoto
Full Access Members
I hit the lottery...
I found a guy who was selling his 2020 Beadlocks and didn't realize what he had. I could not be happier. Thank you Matt for the heads up on the zip ties. Had it done before the wheels arrived. I ground the axle down to the threads but still need a spacer to clear. How far are you guys going?
I found a guy who was selling his 2020 Beadlocks and didn't realize what he had. I could not be happier. Thank you Matt for the heads up on the zip ties. Had it done before the wheels arrived. I ground the axle down to the threads but still need a spacer to clear. How far are you guys going?
Those are chubby AF! Looks good.
I had to remove about an 1/8th from my plastic cap...on top of the .250 spacer. With a lift, your ride will be hot.
Looks great!
AKentPhoto
Full Access Members
I'm undecided on the lift...
My wife is super short and honestly I like the tucked big tire look. It exaggerates them a bit and doesn't effect driving character... Maybe one day when I actually have a chance to get it off road and I realize how low it is... Plus it will be spending a fair amount of time towing so that will have to be taken into account.
Where's the beef??
Rubbing is minimal and I think a couple more zip ties is all I need up front. I'm also thinking of only putting spacers in the back because of that, is that a bad idea? The back seem more pulled in than the front. Slightly... I guess ill order 4 and see how it looks before making the decision.
My wife is super short and honestly I like the tucked big tire look. It exaggerates them a bit and doesn't effect driving character... Maybe one day when I actually have a chance to get it off road and I realize how low it is... Plus it will be spending a fair amount of time towing so that will have to be taken into account.
Where's the beef??
Rubbing is minimal and I think a couple more zip ties is all I need up front. I'm also thinking of only putting spacers in the back because of that, is that a bad idea? The back seem more pulled in than the front. Slightly... I guess ill order 4 and see how it looks before making the decision.
Last edited:
I like it. But I would bet one day you will be in a hurry and pull into a coffee shop or something and rip all the carpet out from under your car. [emoji23]
Sent from my iPhone using Tapatalk
Tys expedition
Well-Known Member
i did a write up on my swap. i cut between 1/4-3/8 off th eagle halfshaft and had plenty of room for the cap. no spacer. ps yours looks awesome. i couldn't find the newer beadlocks for under 2k. i like both and my wife prefers the other ones. i ended up getting eight so i can match a trailer when i get it built
Similar threads
