What Have You Done to Your 4th Gen This Week?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Fozzy

Full Access Members
Joined
Sep 5, 2019
Posts
1,200
Reaction score
1,158
Location
Riverton
Pretty straight forward installation the only issue I have is that I couldn't find an ignition fuse in the engine bay that I'm willing to risk blowing; I currently have it plugged in to the rear heated seats/temp controls which only enough is always hot.

I tapped fuse 15. It’s a 15 amp that runs the cruise control, camera and voltage quality control. What ever that is. I only need 2 amps for the Switch-Pros ignition sensing lead. Not sure what you need for the Triggered.
2db35f145fdda1a437272e0679e48c48.jpg


Sent from my iPhone using Tapatalk
 

Eddie1965

Active Member
Joined
Apr 2, 2020
Posts
32
Reaction score
18
Location
Culver City
I tapped fuse 15. It’s a 15 amp that runs the cruise control, camera and voltage quality control. What ever that is. I only need 2 amps for the Switch-Pros ignition sensing lead. Not sure what you need for the Triggered.
2db35f145fdda1a437272e0679e48c48.jpg


Sent from my iPhone using Tapatalk

That should be enough, just wanted to play it safe with a fuse that if it were to blow, it wouldn't disable a major function of the vehicle. I'll move it over and give it a shot.
 

Robert McMillan

17plati
Joined
May 8, 2020
Posts
201
Reaction score
68
Location
US
where'd you get the badge/cover? Id really like to get rid of all that chrome (on the badge)!
Amazon sells some decent ones, there’s a few dudes that custom paint them also but be ready to put out $200-300 for them
 

Robert McMillan

17plati
Joined
May 8, 2020
Posts
201
Reaction score
68
Location
US

LokiWolf

Super Moderator
Staff member
Super Moderator
Joined
Apr 2, 2016
Posts
3,637
Reaction score
2,446
Location
Richmond VA
How well do these actually adhere? Are there ripples around the edges after you lay the sticker out? I’ve seen issues with these where ppl can’t get the sticker to sit 100% flush since the oval is convex

Just like any other vinyl a little heat goes a long way. Line it up, apply to the center, push side, then top and bottoms, then smooth out best you can. Heat gun on low around the edges in a sweeping motion, or a hair dryer if you don’t have a heat gun. The trick is to hit it lightly. It will pul it tight. Take your time.

I have done my 2015, 2017, 16 Edge, and have a set for my 2020 Explorer, but haven’t applied them yet. When I do, I will take a pic.


Sent from my iPad using Tapatalk Pro
 
Top