Possibly debris squished between back of rotor and hub face ? It would stay there everytime unless wire brushed.
I have same truck with 150K. I don't have that problem but did have one bad upper control arm (you replaced) and one inner tie rod.
Vibration
- Thread starter Lynnii2
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I have same truck with 150K. I don't have that problem but did have one bad upper control arm (you replaced) and one inner tie rod.
OP
OP
Lynnii2
Full Access Members
I ordered front and rear hub wheel bearing and will be replacing the front tonight and the rear in the morning. I will update everyone if this has fixed the problem.
I have replaced everything in the front end. So this is the last thing on the list to do and hopefully this will fix the issue.
I have replaced everything in the front end. So this is the last thing on the list to do and hopefully this will fix the issue.
Last edited:
07navi
Full Access Members
I doubt if that will do anything if you already wiggled the wheels.
OP
OP
Lynnii2
Full Access Members
I will also be doing the drive shaft slip yoke and rear differential fluid change all this weekend. So hopefully this will fix the problem and make the wife happy at the same time.
07navi
Full Access Members
Those slip yokes can bind up inside at the spline and the bushing they ride on can wear out and vibrate the whole truck.
OP
OP
Lynnii2
Full Access Members
That is why i decided to do a service on the yoke and rear differential fluid along with the front wheel hub bearing
OP
OP
Lynnii2
Full Access Members
Hello everyone,
So I replaced the front and rear wheel hub/bearing and the vibration in the steering wheel and shaking has gone away. I also did rear differential fluid change along with the slip yoke and the small bang I would get when taking off and hard stop is gone also. I appreciate a the help from everyone.
So I replaced the front and rear wheel hub/bearing and the vibration in the steering wheel and shaking has gone away. I also did rear differential fluid change along with the slip yoke and the small bang I would get when taking off and hard stop is gone also. I appreciate a the help from everyone.
07navi
Full Access Members
It was all in the slip yoke.
OP
OP
Lynnii2
Full Access Members
I also did the front lower control arms as well this weekend. The truck was driving like new before I did the slip yoke, but I did it anyway just as a route maintenance.
Trainmaster
Old School Member
The slip yokes used to bind and bang in the 1st Gen trucks if not greased with silicone lube.
Last edited:
