2006 RF brake line front crossmember

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Roindhouse

Member
Joined
Jun 29, 2020
Posts
23
Reaction score
6
Location
Ga
Have a 2006 4wd limited

The brake line from the abs box going to the right front wheel , has burst , at the lowest part where it goes across the front frame crossmember next to the steering rack.
Evidently the plastic anchors on the crossmember rubbed a hole in it .

Anyway .
Has anyone ever replaced this line ?
I can order the entire line from the abs to the wheel but
Is there anyway to replace the entire line ?

I don’t see any way to get it out ,
And frankly I don’t see any way to have enough room to repair the line that’s in there with a flaring tool and
A splice .

Any ideas ?

Thanks
 

GAINMOB

Supporting Member
Supporting Member
Joined
May 19, 2010
Posts
14,561
Reaction score
888
Location
Hampton, VA
my abs module went bad and had to be replaced but i paid for the work so i cant tell u anything on it...i want to say that when i asked about the work entailed they did say the entire system had to be purchased and not just the abs module...meaning the lines came with it...check with ur local shop (not dealership) to see what they say
 
OP
OP
R

Roindhouse

Member
Joined
Jun 29, 2020
Posts
23
Reaction score
6
Location
Ga
Just ordered the nice Eastwood flaring tool .
Will get some nicop line and reuse the fittings from this broken line to make a new one .
 

Retiredusps

Full Access Members
Joined
Oct 28, 2018
Posts
188
Reaction score
78
Location
N.J.
I purchased 2 lines and a flare union started at wheel and worked forward. estimated length to buyhard part was up by ac. After I was done noticed it is possible to run it behind front cross member alot easier
 
Top