I have an 03 EB with an aftermarket stereo with factory speakers and sub. I'm trying to set the hpf and lpf for speakers and subs. Not really sure about the gain and slope I have hpf and lpf set at 70 hz.
I'm trying to get the windows wired up with the navigator door panels. The front window switch pigtails don't match the window switches on the front door panels but the rear door panel switches match up with the pigtails in the door. The rear windows don't roll down though. Has anyone done this...
I have an '03 expy eb with 5.4 4wd 205k. It currently needs a new ac compressor and seal changed in transfer case to keep transmission fluid from leaking into it.
My wife wants a newer one like a 13-14 EL. I know the 5.4 2v has less issues than the 3v. Should I fix the problems on the '03 or...
Finally getting around to installing the belltech sway bar and used impact to loosen the bushing bolts and they just spin. I'm assuming I'll have to cut the nuts off, but can't even get to the top side of the one closest to gas tank. Do I have to drop gas tank to get to it?
My battery gets low after 3-4 hours. I haven't had a chance to do a voltage drop test yet but I charged my battery and unhook it after I get to work or home to keep it from going dead. I charged it today to 100 percent. I hooked up battery and drove 40 miles to work then unhooked it. The drive...
I'm gonna have to daily the expedition and I drive 400 miles week for work. So far I pulled out the middle seat in 2nd row, removed running boards, and the muffler and tail pipe. Im going to remove the roof rack and the front drive shaft until winter hits. The AC doesn't work, if I bypassed the...
I already had the dual monitor stand, it's an ergotron brand. I don't have a part number but if you search for rear wiper delete on Amazon it shows a bunch of plugs.
You can grab the edge of the glass after you hit the release button. After I took the wiper off, I just unbolted the latch which has the wiper shaft on it. I then cut the part of the bracket that had the shaft on it. Now all I have is a hole in the glass which is about the size of a 22 mm...
I dropped the pan yesterday and changed filter. When I put pan back up I torqued pan to 120 in lbs. I checked fluid level again today and had to add some. It looks like fluid is seeping out a little. I might tighten pan to the max torque spec and see if the helps. If not, what is next new oem...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.