Search results
-
REALLY wide tires...
Well, I found a great deal on a set of 375/60/18 Mickey Thompson MTZ's... and I mean a REALLY good deal. I am very concerned that I will have major trouble fitting these tires. Currently I'm running 6" of lift in the front and 5" of lift in the rear with 35" tires... (they clear no...- NC-Expy
- Thread
- Replies: 6
- Forum: General Discussion
-
Bolt Pattern
Is there another bolt pattern that would work on the 97-02 models? I hear of a lot of people talking about 5x5.5 or something, but as far as I'm concerned it's only 5x135? Or are these the same thing? Sorry not 100% educated on bolt patterns.- NC-Expy
- Thread
- Replies: 10
- Forum: General Discussion
-
Big Problem
Terrible front end bounce at any moving speed, including reverse and 4wd High and 4wd Low. Front end is also very stiff and will not bulge when trying to bounce on it while it is parked. This all started directly after replacing driver side CV axle. Used the original axle nut as well as the...- NC-Expy
- Thread
- Replies: 5
- Forum: General Discussion
-
Door lock actuator
Having trouble with the locks, it's only 3 out of 4... Mainly drivers side door. Going to switch actuator out to make sure before I switch the relay. Does anyone have a write up of how to replace the relay and where exactly is the actuator once I remove the drivers side door panel?- NC-Expy
- Thread
- Replies: 0
- Forum: General Discussion
-
Exhaust
So currently I have my rear 2 cats deleted and true duals with flowmaster super 10's... Would swapping my FRONT 2 OEM cats with Maggies make it a little louder? Or will the $200 exhaust job not do anything for me? Also as far as sound goes for these 5.4's would you recommend an H pipe, X...- NC-Expy
- Thread
- Replies: 16
- Forum: General Discussion
-
Battery Draining?
I have no issues when the truck is running and moving, the battery tested good and the alternator tested good. They are both brand new. When the engine is on but not running, the voltage gets really low and the battery begins to drain about 10 minutes in. If I don't crank the truck right away...- NC-Expy
- Thread
- Replies: 3
- Forum: General Discussion
-
Emblems
How big are the holes behind the emblems on the side of our trucks? Was thinking about taking them off, and putting these on to cover the holes. Ford Mustang Black Chrome 5 4 High Performance Emblem | eBay- NC-Expy
- Thread
- Replies: 5
- Forum: 1st Gen - 1997 - 2002
-
Where'd everybody go?
none of the same people are on here anymore... seems we have lots of new members but none of the usual people are on anymore.... panda, walnuts, solisimo, dgray, nvycrmn, racenut, etc.... everybody sold their expo's i guess!- NC-Expy
- Thread
- Replies: 17
- Forum: General Discussion
-
Dana 44 Swap
How much work/cost would it be to do a straight axle swap front/rear on an Expo? I'm tired of switching out ball joints/CV axles every other month it seems... and figure if I throw a Dana up front, I might as well do the back too. How much work do you guys think this would be and how much...- NC-Expy
- Thread
- Replies: 2
- Forum: General Discussion
-
IAT Sensor temperature?
What should the temperature of the IAT sensor be that goes into the intake? Mine is reading at 100 degrees Fahrenheit and I have read that it should be exact or close to your coolant temperature... My coolant reads at 190 degrees Fahrenheit and that's a good ways off from the IAT temp...- NC-Expy
- Thread
- Replies: 10
- Forum: General Discussion
-
Appearance Question
Do you guys think my truck will look stupid if I go ahead and do the body lift but stick with my 35" tires for now... I don't have money for 37's at the time and I really want to go ahead and lift it higher. 37's for an 18" rim are not cheap! I've got 325/65/18 tires on it (34.6/12.8/18)...- NC-Expy
- Thread
- Replies: 1
- Forum: General Discussion
-
Good idea or bad idea? LED light bars
RECON 62" BIG RIG LED RUNNING LIGHTS BARS LINE OF FIRE | eBay- NC-Expy
- Thread
- Replies: 6
- Forum: General Discussion
-
what the hell is this?!
POLARIS EXPEDITION 425 1999-2002 HIGH LIFTER LIFT KIT | eBay- NC-Expy
- Thread
- Replies: 8
- Forum: General Discussion
-
Will these help with my rear end squeaking?
Energy Suspension Bushing Rear Sway Bar Set Ford Expedition Navigator 22mm Red 703639336013 | eBay Do consider, I have brand new coil springs, brand new shocks, brand new sway bar linkings, brand new control arms, brand new ball joints, brand new innter/outer tie rods, etc... So pretty much...- NC-Expy
- Thread
- Replies: 1
- Forum: General Discussion
-
Just Ordered :)
Just ordered another Edge CS Programmer as well as the Pod.... I had one of these before and had to sell it due to financial trouble, now thought I'd bite the bullet and buy it again... $373.15 free shipping... they are on sale! Can't wait!- NC-Expy
- Thread
- Replies: 5
- Forum: Engine & Performance
-
Aftermarket Mirrors
I really want some... can someone PLEASE find some damn aftermarket mirrors for 1st gen's... :( I feel like it would complete my truck so much... I'm very skeptical about trying the 2nd gen mirrors on my truck, it would look great though. I have power, heat, and turn signal... So don't...- NC-Expy
- Thread
- Replies: 8
- Forum: General Discussion
-
3 Inch Performance Accessories Body Lift
Are the instructions included with this lift kit very self explanatory and easy to follow? I want to order the lift, but do NOT plan on paying someone $600-$700 to install this for me. I'd like to do it myself. Without easy access to air tools and a very tight schedule, do you guys think I'd be...- NC-Expy
- Thread
- Replies: 7
- Forum: General Discussion
-
Backwards third row seat
This question is specifically towards Expeditionary but also applies to anyone that knows the answer... Do you have to modify anything to put the third row seat in facing backwards? The brackets on the seats themselves seem to be a little different, so was wondering if I needed to unbolt...- NC-Expy
- Thread
- Replies: 7
- Forum: 1st Gen - 1997 - 2002
-
CAI Installed, Now CEL
So I pretty much stole a CAI by K&N today... 40 bucks off Craigslist, came with the box and everything. Aftermarket filter though, apparently one that's better than K&N, whatever. So after installing it, I've got a check engine light. The code is P0113, which is related to the IAT (Intake Air...- NC-Expy
- Thread
- Replies: 8
- Forum: General Discussion
-
This message is for baker
Where did you get that push bar on your truck?... I've been looking all over for one, but can't find one ANYWHERE. Warn makes one for like $750, but I think I'd rather stick a fish hook through my testicles before paying that much... lol- NC-Expy
- Thread
- Replies: 2
- Forum: General Discussion
-
Expy for sale
LIFTED Ford Expedition 5.4L V8 Eddie Bauer spread the word if you guys don't mind. -
Look what i found
This is for sale in Wilmington, about 3 hours away from me! LIFTED '97 Expedition 4x4- NC-Expy
- Thread
- Replies: 3
- Forum: eBay & Craiglist Listings
-
WTF is up with my dome light?!
Click on the video attached, My dome light keeps flickering every now and then... I don't know what to do, it's SO annoying! Also, it's ONLY that one doing it. The one on the right is fine, and all the ones in the rear are fine. http://youtu.be/dPrZtJEV5Nw By the way, don't know how or...- NC-Expy
- Thread
- Replies: 11
- Forum: General Discussion
-
How to: Remove air intake silencer 1st gen
Has anybody done this? A write-up would be helpful or just some quick/easy steps. I am only doing this for noise increase.- NC-Expy
- Thread
- Replies: 27
- Forum: General Discussion
-
Problem. Someone help?
I got the LED lights for the front overhead console. Right side works, no problems. Factory halogen bulb was working OK in the left side, I took it out to put the LED in there, didn't work. Took it out, now the halogen bulb won't work either. What should I do? I don't know how I could have...- NC-Expy
- Thread
- Replies: 5
- Forum: General Discussion
