Set to open on set up menu.. Open door and force the running board down, you will need to pull on it while you here the motor.. If you don't hear the motor working they won't go down..
Sent from my LM-G710VM using Tapatalk
You can do two things for a quick fix.. 1 force the running boards to open then in the set up menu set running boards to open... Or you can force the running boards open then unplug the motors... But personally I would try cleaning the motors with degreaser and get any debris that could possibly...
Check for the gps/antenna leads. They should be up in the glove box area, they are colors pink & mustard looking connections, sorry in no engineering lol... Find the connections and check for rust build up. Get dielectric grease, clean connections and use grease, next check the GPS antenna on...
The harness comes from the nav system when the truck is built.. Its a separate option so ford goes by what options the truck will have , so if its a simple cd/radio.. The wiring harness is pre-installed on the main harness, but if it has the nav/back up camera it needs a separate harness that...
No, you can't just swap radios.. You will need the amp and the radio harness.. Also there's a wire that goes to the module under the center console.. Watch the video...
Sent from my LM-G710VM using Tapatalk
You can but its an expensive upgrade if you want to stay factory... Just YouTube or google ford expy factory radio installation.. All the info will be there even for aftermarket parts
Sent from my LM-G710VM using Tapatalk
Thats it, there's only two up in the dash, the third is in the rear right side panel... That controls the temp in the back...
Sent from my LM-G710VM using Tapatalk
Hmm..
Maybe try resetting... The remote start computer.. Disconnect the module and then disconnect the battery terminal, turn the ignition to on position to drain the rest on the system then connect battery, then the module... If the keyfob doesnt work just follow the instructions on programming...
The water will always get in there... The problem is that the holes are clogged with debris.. To fix the problem take a flathead screwdriver to get the dirt and debris out, then put the plastic cap back one...
Sent from my LM-G710VM using Tapatalk
If its the antenna, u will have to get to it somehow and tighten up the bolts... But it should still be under warranty, so I would just bring it to the dealer and let them fix it...
Sent from my LM-G710VM using Tapatalk
Go onto youtube, there are videos on checking the camera.. Most likely its the settings in to main screen that needs to be turned on
Go to settings
Backup camera
On - off
On
Then check in reverse...
Sent from my LM-G710VM using Tapatalk
Check the right side pillars for the camera wire.. Should be an rca looking wire...
That's where the wire is ran on the 07-15 models... I'm not sure about ur truck though
Sent from my LM-G710VM using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.