Search results

  1. martinek

    Air suspension compressor air dryer

    Is it possible, and if so, how, to convert my 1 outlet factory air dryer to my replacement air dryer with 2 outlets?
  2. martinek

    High performance intake manifold needed

    I have a 1998 Expedition, 4X4, Eddie Bauer, 5.4L. I blew my intake gasket and since I need to change it, I'm looking for a high performance, preferably chrome, intake manifold, upper and lower, gaskets and mounting hardware kit. Does anybody have any suggestions of where to find exactly that...
  3. martinek

    sputtered when driving and just died.... wont start? Fuel pump?

    I usually disconnect the fuel line at the throttle body area then crank it over. If gas comes rushing out, then it's not a fuel pump. If you get no gas, then it's fuel pump.
  4. martinek

    My 1997 is shuddering/chugging at speeds over 45mph

    Have you tried hooking up a gauge and checking engine codes?
  5. martinek

    Door keypad code

    How do you reset that door keypad code? Curious.
  6. martinek

    PO171, PO174 engine codes

    I keep getting the PO171 and occasionally the PO174 codes. I have replaced my PCV valve and ALL the lines, including the 90 degree boot on the back of the engine. I have put clamps on all the connections. I used starting fluid to spray when it runs rough and it keeps coming back to the little...
  7. martinek

    AC Not Cold, Heat not hot

    I have a 1998 Expedition, Eddie Bauer, 4X4, 5.4L Triton. My AC is not cold. It is blowing cooler than outside air but not cold. My Freon is in the good mark, not low, not high. My compressor is kicking in and working fine. Also, when I put on the heat it blows warm but not hot. What could...
  8. martinek

    Cruise Control not working

    How do you start a new thread?
  9. martinek

    Cruise Control not working

    My 1998 Expedition 4X4 Eddie Bauer 5.4L Cruise stopped working My cruise stopped working. It worked on my way to work. I shut down my truck, went to work, came out to go home and it was no longer operational. The switch on the master cylinder had fluid around it. I pulled it out and...
  10. martinek

    Low Washer Fluid light

    My 1999 Expedition XLT has the washer light on all the time. What is the problem? It's full.
  11. martinek

    cruise control not working

    I have a 1998 Expedition Eddie Bauer 4X4 5.4L Triton. One day my cruise control stopped working. i used it on my way to work and when I got done and tried to use it on my way home, it wouldn't work. My "Deactivation switch" on the master cylinder was leaking. I let it alone and forgot about...
  12. martinek

    Overhead console removal

    I replaced my bulbs, (194 bulbs), with the same 194 LED bulbs I put in my dash but they still don't light up. Any suggestions?
  13. martinek

    Overhead console removal

    Well I figured it out. Pull down hard on the rear to release the clip. It will drop about a half inch down. Then go to the front of the console and pull down as well releasing the front two clips, (one on left side, one on right side). Slide console towards the windshield to pull bracket...
  14. martinek

    Overhead console removal

    How do you remove the overhead console on a 1998 Eddie Bauer Expedition? I need to replace my heater control lights. It will not light up at night.
  15. martinek

    overhead console

    I have a 98 eddie bauer expedition. How do you remove the overhead console without breaking it?
  16. martinek

    Las Vegas with an Expedition challenge

    I have a new pending trouble. Check engine with codes PO136 PO156 PO174 PO171 P1131 P1151. Now what?????????????????????
  17. martinek

    Rough idle? P0171, P0174? Here's what you need to check first!!!

    I had recently changed both my upstream O2 sensors and the PCV elbow. My truck ran great once again and check engine went out. I now have it running rough, wanting to stall and I get 6 codes, PO136 PO156 PO174 PO171 P1131 and PO1151. I have a 1998 Ford Expedition Eddie Bauer 4X4 5.4L Triton...
  18. martinek

    Las Vegas with an Expedition challenge

    No I don't follow the schematics. Brake lights work, horn works and all fuses are good.
  19. martinek

    Las Vegas with an Expedition challenge

    I'm sorry I'm sorry, those schematics are fine but I'm not an electrical engineer. The only thing electricity and I have in common is the entire time growing up I was always grounded. I'm attempting to find out the CAUSE of my cruise going out.
  20. martinek

    Las Vegas with an Expedition challenge

    I have a 1998 Expedition. The cruise worked this morning but did not this afternoon. I have no "on dash" cruise light, never did. The connector on the master cylinder has the recall jumper harness on it with the fuseable link inside. There is brake fluid inside the switch connector. My volt...

Latest posts

Members online

Forum statistics

Threads
53,391
Posts
500,598
Members
46,798
Latest member
geovanni
Top