Search results

  1. M

    Parting out whole 2003 4.6 2wd black

    Yes Sent from my SM-G928T using Tapatalk
  2. M

    Parting out whole 2003 4.6 2wd black

    Tell you the truth, if i can get it complete, with bumpers & fender flares, then im good to go Sent from my SM-G928T using Tapatalk
  3. M

    Parting out whole 2003 4.6 2wd black

    Absolutley, thanks for the heads up. Sent from my SM-G928T using Tapatalk
  4. M

    Parting out whole 2003 4.6 2wd black

    Lol, i hear you. Ive been looking for the fender flares from the eddie bauer for my 2003 xlt for a long time. Was hooing i caould get them here. Sent from my SM-G928T using Tapatalk
  5. M

    Parting out whole 2003 4.6 2wd black

    Didnt see that, thanks. Tgey should really remove the posts when its this long Sent from my SM-G928T using Tapatalk
  6. M

    Parting out whole 2003 4.6 2wd black

    Is this the eddie bauer edition? Sent from my SM-G928T using Tapatalk
  7. M

    2003 ford expedition

    Pm sent Sent from my SM-G928T using Tapatalk
  8. M

    2005 ford expedition air cond. problems

    These expedition have a acuator that changes as you change the location of the vents, on the acuator door the hinges have a tendency to break. If this happens, the air will come out of the one postion. I would start there. Also check the hoses going to the controller. A filter will not cause...
  9. M

    Timing chain

    If the timing chain is making noise, then you change it, it intales replacing the chain guide rails, tensioners & 2 chains. Also you must check the sprockets to make sure none of the teeth are broken. You must check for any metal dropping in the oil pan. Ive done these, its really not an easy...
  10. M

    suspected intermittent fuel pressure drop

    If this is happening intermittently, then you turn off the key, wait a few minutes, then the truck starts. It sounds to me like the security system might have an issue. When you turn the key off, it seems like your resetting the PATS system. I would look into either the key chip or the PATS...
  11. M

    Engine Help - Problems persist

    The 2nd posting was for the 1st posting, just letting you know where I got the info from sorry for the confusion. Listen, if you have a MAF issue, normally you should get a code. Im thinking when your engine is hot, your ECM might be shorting out or you have a shorted wire somewhere. Obviously...
  12. M

    Engine Help - Problems persist

    I found this online. Hope this helps
  13. M

    Engine Help - Problems persist

    Possible Solutions The main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit. Notes: Dealer techs have advanced...
Top