Search results
-
4wd Vacuum Hub Line
I have managed to disconnect my drivers side vacuum line for my 4wd actuator hub.. It is the skinny one and came disconnected somewhere over the shock tower. I can’t find the other end to reconnect. Does anyone know where the connection is located or from where it draws its vacuum?- WhiteFalcon
- Thread
- Replies: 3
- Forum: 2nd Gen - 2003 - 2006
-
Transmission Missed Shift/Slip
I have a 2005 Eddie Bauer and just had the transmission rebuilt. Everything has been working fine for about 2,500 miles but I have experienced two instances where the transmission feels like it missed third or fourth gear. The transmission will slip and then eventually find its gear. I was...- WhiteFalcon
- Thread
- Replies: 6
- Forum: 2nd Gen - 2003 - 2006
-
P0720 Reverse No Forward / Limp Mode
On my 2005, I changed the fluid one week ago. It was dark but not totally burned. Had about a tablespoon of friction material on the magnet. Yesterday while driving on the freeway it started shifting erratically and then the o/d light started flashing. When I got off, I lost forward and...- WhiteFalcon
- Thread
- p0720
- Replies: 1
- Forum: 2nd Gen - 2003 - 2006
-
p2101 Throttle Actuator Control
Hello All. After conquering the AC P0351 issue, the truck is now again running like crap and showing a p2101 Throttle Actuator Control code. It was running perfect this morning when I drove it to work and when I came out to drive home tonight, this code and it won't run at more that about 20...- WhiteFalcon
- Thread
- Replies: 1
- Forum: 2nd Gen - 2003 - 2006
-
Air Conditioning PCM Control
My ac stopped working and I traced it back to the pcm failing to issue a ground command to the clutch relay. Is this a common issue and do I need to replace the pcm? I don’t see any issues with the wiring from the relay back to the pcm.- WhiteFalcon
- Thread
- Replies: 8
- Forum: 2nd Gen - 2003 - 2006
-
AC Stopped Working
On my 2005, the AC system stopped working (of course when it was 102 degrees outside). Here are the stats: System charged; static pressure 60 low side and 20ish high side; pressure when running 140 low side 50ish high side. No cooling even when running. The clutch air gap looks good...- WhiteFalcon
- Thread
- Replies: 23
- Forum: 2nd Gen - 2003 - 2006
-
Timing Chain Replacement
I am experiencing the rough idle issues that are caused by either the phasers or tensioner on my 2005 3v. It is also throwing a P00012 code on the right bank. I am pretty mechanically inclined and want to tackle changing the timing chains, phasers, tensioners and guides. Wanted to see how...- WhiteFalcon
- Thread
- Replies: 8
- Forum: 2nd Gen - 2003 - 2006
-
Box Behind the Battery
On my 2005, I was removing the battery and it got caught on a black plastic Box that sits behind the battery on the outside edge near the fender. When I yanked up, there was a hissing noise like some sort of pressure release. Two questions: what is that box for and does it have something...- WhiteFalcon
- Thread
- Replies: 11
- Forum: 2nd Gen - 2003 - 2006
-
2005 cruise control
I just bought an 05 and the cruise is not working. I have seen posts that it is likely the deactivation switch in the master cylinder. For some reason, mine does not have a switch on the master cyl. Was there some sort of redesign in 05? Where else should I look for this switch?- WhiteFalcon
- Thread
- Replies: 5
- Forum: Electrical
