Search results

  1. A

    Rear HVAC door Actuator Calibration Procedure, Issues after battery replacement.

    It’s a 2013.
  2. A

    Rear HVAC door Actuator Calibration Procedure, Issues after battery replacement.

    Well I confirmed both rear actuators are fine. The issue is the mode actuator has calibrated itself to far one way (heat/floor), and not enough the other way (Cool/ceiling). The clicking I was hearing was it running out of travel space in the heat mode. I just got into ceiling mode and...
  3. A

    Rear HVAC door Actuator Calibration Procedure, Issues after battery replacement.

    I can hear them trying to do the calibration procedure (didn’t realize that’s what they were trying to do), but they’re both clicking now. They were fine prior to changing the battery.
  4. A

    Rear HVAC door Actuator Calibration Procedure, Issues after battery replacement.

    I installed a new battery today. After the install both rear actuators seem to be out of calibration. They worked fine before the battery swap. I have found conflicting information on what exactly the procedure is to re-calibrate them. Does anyone have the re-calibration procedure for the...
  5. A

    Rear HVAC will only blow cold.

    2013 Expedition. So my rear HVAC will only blow cold. The mode door works as I can get it to change to the different modes (floor/ceiling), but the air is always cold. I connected Forscan and got a B2916 - rear blend door circuit fault. Any ideas?
  6. A

    Sunroof repair

    Reviving again! Getting ready to tackle this job with the Sunroof DR kit. When dropping the headliner do you have to remove the vents/registers, or do they drop with the liner? Thought I saw a thread earlier where I think it said you did not have to remove them, but I can't find that one...
  7. A

    Yet Another AC Thread

    My 2013 was recently doing this and it turned out to be the outside air temp sensor. I could see it on the display too. The outside air would randomly go to -25° and it would switch from cooling to heating. I also used forscan to reset the HVAC control module after I switched the sensor.
  8. A

    Coolant flush question

    Haven't done my Expedition yet, but on other cars I always flush until clear with distilled water. Then when I take the coolant capacity divided by 2 and put that amount in straight coolant. I do this because its it impossible to get all the water out after a flush, and therefor IMO get a true...
  9. A

    No Brake Lights

    Do you have access to a multimeter? I would check to see if you're getting 12 volts at the brake lights. Do they flash when your hazards are on? Did you buy an OEM brake switch? Maybe the new switch is bad out of the box. Here's a diagram for your model.
  10. A

    Fan Clutch issue

    Unplug the fan clutch under the same conditions and see of it's getting it's 12v signal. If there's 12v then it's likely the fan clutch, if its not then maybe your PCM.
  11. A

    Fan Clutch issue

    Sounds like it's working as it should. The fan should not run full bore all the time. Especially if the engine has not warmed up. Are your coolant temps good and AC working ok?
  12. A

    Convert 2nd row bench to captains chair's

    Still interested in swapping 2nd row seats? I have a 2013 with tan leather bench seat. I'll swap your captains for my bench. I'm in North GA.
  13. A

    I replaced both factory amplifiers and subwoofer (with bonus wire colors / wiring diagram)

    Did you stick with the OEM 20amp circuit for power?
  14. A

    Upgrade OEM stereo head unit.

    @mr_dave For the door speakers, is there another OEM amp or radio control module in the dash for them, or are they fed straight from the back of the OEM HU?
  15. A

    Upgrade OEM stereo head unit.

    Question below from your post. Rear subwoofer amplifier: - brown/red +12v - Did you use this to power your aftermarket amp? Doesn't seem like it would be enough to power aftermarket equipment. - black/blue chassis ground - purple/red +6v switched - is this a power on signal? Does it come...
  16. A

    Upgrade OEM stereo head unit.

    Did you use the pre-amp inputs on your new sub amp, or just the OEM inputs for the factory sub amp on the new one?
  17. A

    Upgrade OEM stereo head unit.

    I thought about that, but I hate the factory unit with every fiber of my being. It doesn't even display artist/title from Bluetooth. Even in 2013 that was a common thing. Just awful! Thanks for posting the pic though. I haven't installed my system yet and didn't realize there was so room...
  18. A

    Upgrade OEM stereo head unit.

    Mark, Did you use a Maestro RR for your install with accompanying maestro harness? I was wondering if you followed the instructions and cut the RCA connectors off and spliced in your front and rear speakers, or retained the RCA connectors and used the head unit pre-outs. I've seen both...
  19. A

    SOLVED! Looking for a replacement key/fob confirmed to work, 2013 Expedition

    Yes, see below. Switchblade key confirmed to work
  20. A

    SOLVED! Looking for a replacement key/fob confirmed to work, 2013 Expedition

    Well it was operator error on my part. I used the following to get the key fully programed. Cutting the key - Had to take the key to my local locksmith to cut it. Cost me $10 for that. Ace and Home depot machines could not cut the key due to the design of the switchblade. Programing the...
  21. A

    SOLVED! Looking for a replacement key/fob confirmed to work, 2013 Expedition

    Bought a 4 button with w/ rear lift gate button of Amazon. Amazon said it was a "fit" for my Expedition. The key worked after reprograming with Forscan, but after two tries at programing including erasing all keys and re-adding them I can only get the key to work, but not the buttons on the...
  22. A

    Upgrade OEM stereo head unit.

    @Mark Buckner Could you share a pic of your install? With the 10" Kenwood (DMX1057XR) I was hoping there is enough screen adjustment up and down to center it between the buttons and the HVAC controls. The Kenwood screen is just over 7" tall and has 5 adjustment points built in. I like the...
  23. A

    Upgrade OEM stereo head unit.

    Yeah as I’ve been researching. I’m starting to lean more and more towards aftermarket. Of course for that I’ve been leaning heavily on crutchfield’s Information. I’m looking at one of he 10” Kenwoods with the maestro and idata link to retain all the OEM functions and gain some. The Kenwood...
  24. A

    Upgrade OEM stereo head unit.

    I have a new to me 2013 Expedition with the OEM navigation stereo. (Not sure if it’s Sync or what? See pic). I would like to install something with CarPlay. I’m fine with an aftermarket option if that what it comes to, but would really like to upgrade to Sync 3. I can’t seem to find any options...

Latest posts

Members online

Total: 848 (members: 6, guests: 842)

Forum statistics

Threads
53,652
Posts
502,789
Members
47,268
Latest member
gnorman

Share this page

Top