-
-
Mmax78 replied to the thread 2009 fix or sell?.Before you invest any money into it check your thrust bearing clearance with a simple test, or have a shop do it...
-
Mmax78 replied to the thread Front AC not working.Wow, that's always a bummer when you are chasing a problem and it turns out to be a brand new part that was supposedly tested good from...
-
Mmax78 replied to the thread Front AC not working.Have you tried jumping the relay connection to see if it powers on at all? That will help you narrow it down from either a power issue...
-
Mmax78 replied to the thread Front AC not working.In my case unplugging the actuator allowed the blower motor to work until I get a new actuator on hand. Maybe give that a shot?
-
Mmax78 replied to the thread Front AC not working.I would start by checking the fuses if you went and spliced things with the battery connected. I think spot 51 is a 40 amp relay for the...
-
Mmax78 replied to the thread More in depth high mileage maintenance.226K miles now, from 180K till now these are the things that I replaced preventatively. Fuel pump (it was loud once but still...
-
Mmax78 replied to the thread Load Range E tire pressure.It depends on the tire more than the rating, but when empty I'm around 35 to 40 psi.
-
MI did the same job on a 4.8L 2010 Explorer with 135,000 miles. My followers and cams were fine, so I did exactly what Max did: I held...
-
Mmax78 replied to the thread 2013 Washer Fluid Pump Replacement.Super simple, as everyone stated pop the passenger side headlight out and swap the pump, its a 10 min job.
-
Mmax78 replied to the thread Clicking sound....I had this same exact issue with the i think hot/cold actuator under the drivers side dash tucked up under towards the center consol...
-
-
Mmax78 replied to the thread Timing job questions.I left everything on the valvetrain untouched and intact, I used a pair of vice grips on the rough casting part to hold the cams in...
-
Mmax78 replied to the thread 09 3v power loss "cured" with 5w40.Think it was something I sprayed on it to clean it. Maybe I grabbed the wrong can of cleaner when I did the bulkhead sleve, I don't...
-
-
Mmax78 replied to the thread 09 3v power loss "cured" with 5w40.Update: Truck died, dash lit up light a Christmas tree, No connection to anything. Found an issue with the transmission plug. . ...
-
-
Mmax78 replied to the thread Documenting: 2014 5.4l 3 valve early oil pump and tensioners upgrade.Cool experience. I did my timing at 175k ish, only one tensioner was slightly blown, no noise issues. I did the Melling timing kit with...
-
Mmax78 replied to the thread AC Pressure High before filled to capacity.The pressure is not too bad, but the fact you didnt get to your rated capacity makes me think that you might have a condenser issue. It...
-
-
Loading…
-
Loading…
