Recent content by CooterExpedition

  1. C

    Driver side power seat failure.

    Only the lumb Only the lumbar inflator works, I will check the relays or fuses mentioned.
  2. C

    Driver side power seat failure.

    Hello, I have an 09 Eddie Bauer and the power drivers seat is stuck in its most rearward position making my wife stretch to reach for the pedals. Is there a fuse or relay to check? Or is it common for the motor to die? Thank you in advance.
  3. C

    2009 Eddie Bauer EL 4x4 clunks when turning left or right

    Tie Rods? Sway bar bushings? 168,000 miles. Just wondering if anybody has had a similar issue. I already searched did not come up with much. thank you in advance.
  4. C

    2009 Expedition remove brake booster

    Ya, I bench bled the master again, watching from the driver seat, had the reservoir filled, pumped till the looped tube was solid fluid, quickly reattached bled the line towards the front of the vehicle 1st, then the one closer to the driver. Then bled all 4 corners again. Still crap...
  5. C

    2009 Expedition remove brake booster

    This crap is killing me!
  6. C

    2009 Expedition remove brake booster

    So far this is the most frustrating pain in the ass issue I have ever seen. No codes. No lights. I have a spare booster but this makes no sense. I don't have a hard brake pedal. Vacuum is just fine. It's just super soft. Like there no hydrolic pressure at all. The brakes just work at the last...
  7. C

    2009 Expedition remove brake booster

    Not sure, it's tough because you have to fold yourself in the foot we'll upside down with your legs up on the driver's seat of you can hang them out the door but then you get your back pressing against hard plastic edges. Now I am trying the ABS/RSC Module. I removed it, sprayed a few cans of...
  8. C

    2009 Expedition remove brake booster

    I took a photo today, see bottom of post, ya it's barbed, but now I need to remove it to replace the booster. I really don't want to break it.
  9. C

    2009 Expedition remove brake booster

    Has anybody removed the brake pedal retaining pin? I replaced the master cylinder with new, bled system, no leaks and the brakes are still way soft. Gotta stand on it to stop. Mush all the way through. I have a new booster but I gota move the his barbed pin. Anyone? The picture is the reverse...
  10. C

    2009 Eddie Bauer Brake 4WD problem

    No codes of any kind. I looked around this forum and Googled. Is there any writeup on purging air from 3rd gen expedition abs units? I could not locate it...and as I said, I have already installed a rebuilt master cylinder. No fluid leaks, now when I first installed the new master cylinder...
  11. C

    2009 Eddie Bauer Brake 4WD problem

    Brake issues. Occasional Soft brake pedal, goes to floor, have to stand on it pretty hard to stop. Occasional means 50/50 could be soft could be hard, could start out kinda hard, but as you press it slowly goes to floor. Replaced Master Cylinder, bled lines different times with little bleed...
  12. C

    04 with 260k miles...........how far should i push my luck ?

    Go to about 35 minutes into this YouTube link.
  13. C

    04 with 260k miles...........how far should i push my luck ?

    Get the tuff plate for $35 too. It includes a cap to protect it from the 2-3 shift accumulator denting the stock plate. After 250k miles it may well be damaged. You can pull the valve body and leave everything else in the transmission.
  14. C

    04 with 260k miles...........how far should i push my luck ?

    You should be able to find the solenoids for less. I got these and they are working great.
  15. C

    04 with 260k miles...........how far should i push my luck ?

    Thanks, I'm speaking from experience, it happened to my 2001 F150 with 150k miles on it. I had to replace just about everything in the transmission case. It's better than original with rebuilt pump, all major sub components rebuilt, solenoids, sonnax sure cure kit, tuff seperator plate...
See more

Latest posts

Members online

Total: 1,604 (members: 29, guests: 1,575)

Forum statistics

Threads
53,696
Posts
503,105
Members
47,344
Latest member
jmdunham2

Share this page

Top