Recent content by JJP1351
-
IN NEED OF THE ELECTRICAL GURU'S!!!
Ok. I'll check it tomorrow when it's not monsooning. Thanks. Wife went thru a puddle an hour ago and all electronics in the dash went pinball machine style.- JJP1351
- Post #8
- Forum: 1st Gen - 1997 - 2002
-
IN NEED OF THE ELECTRICAL GURU'S!!!
Maybe this will help explain. Not alt problem. Power is 13+ no matter what is on or off.- JJP1351
- Post #5
- Forum: 1st Gen - 1997 - 2002
-
IN NEED OF THE ELECTRICAL GURU'S!!!
Terminals are clean. All is rust free inside. Slight edit. Speedo and tach are flat lined and odo has dashes across it with the theft light flashing when I can get it running. WTF! original info was what my wife told me.- JJP1351
- Post #3
- Forum: 1st Gen - 1997 - 2002
-
IN NEED OF THE ELECTRICAL GURU'S!!!
Ok, this morning the dash board stopped working, gauges and ses light, and the windows and wipers stopped working after the needles all looked like the wipers for 3 or 4 seconds. Then, everything was fine for about 10 minutes this afternoon. Now, the power in the dash is flickery and the truck...- JJP1351
- Thread
- Replies: 11
- Forum: 1st Gen - 1997 - 2002
-
Weird blend door?!?!
Thanx Bedrck. But, already knew its wired. Just thought out of ALL the electrical problems these Fords have, someone would have had the same problem and could verify a fix. But since its on its last season more than likely, i'll just break the actuator motor and just use a lever thru the dash to...- JJP1351
- Post #5
- Forum: Heating & Cooling
-
Weird blend door?!?!
The blend door for my heat/cold. The switcher is run by vacuum. The blend door is a few wires. Thanx for the effort tho. It's gotta be my blend door motor. Cuz it won't move at all now.- JJP1351
- Post #3
- Forum: Heating & Cooling
-
Weird blend door?!?!
Ok. all summer been dealing with heat on long drives coming from vents even though controls are set to cold. Yes there the dial kind. Finally cut open the dash, blend door is pinned wide open and don't wanna move. Hmmmm. Start the truck, blend door closes, swings half open, closes then wide open...- JJP1351
- Thread
- Replies: 4
- Forum: Heating & Cooling
-
Identifying front diff. (axle)
Yes, it's the Auto AWD with Hi Lo. It's got a low grinding feeling in the floor as your traveling down the road. Took it in and was told the front diff was going bad. Was going to just take out the cv's and pull fuse #104 and make it a 2WD till I got under there and realized how easy it would be...- JJP1351
- Post #5
- Forum: 1st Gen - 1997 - 2002
-
Identifying front diff. (axle)
How do i identify which gear and if its got the vacuum disconnects in the front diff? I've searched the forums but can't find the answers. Even googled it.- JJP1351
- Thread
- Replies: 4
- Forum: 1st Gen - 1997 - 2002
-
Overheating problem!!!
Temp is fine for over an hour of driving main rds. Get on the freeway for a mile, gauge pegged! Overheated and oil light came on. Look under hood, over flow empty. Refill, a few gallons, running great. Next day, no puddles any where, been checking since yesterday, running warm. open hood, air is...- JJP1351
- Thread
- Replies: 1
- Forum: 1st Gen - 1997 - 2002
-
Amp Power Wire
Gotta question. Any ideas of a good spot, on the battery side, to run 0 gauge power wire thru the fire wall? Poked around a bit, but cant find a place to run it. Any suggestions would be greatly appreciated.- JJP1351
- Thread
- Replies: 10
- Forum: Audio & Electronics
-
High beams and rear wiper acting up...actually not acting at all.
Any luck? My rear motor has no power and all fuses have been checked and tested.- JJP1351
- Post #18
- Forum: 1st Gen - 1997 - 2002
-
-
Back door windows?
Yes i meant the back door windows. My daughter hates them sticking up and I don't like the way they look. Signature fixed. -
Back door windows?
I can't find a post or thread on here about this. Is there a way to get the back windows to go all the way down?
