Recent content by kidphc
-
K
01 Exp Rubber Vaccum Manifold Question
I can't find the part number. I can find the entire hose assembly on E-bay. Just can't find which assembly it is on fiche, so I can give it to my Ford Dealer parts clerk to get me a good part number. Might be easier if you walk into a Ford Dealer and have them look for it.- kidphc
- Post #4
- Forum: 1st Gen - 1997 - 2002
-
K
A couple of rear axle questions
Lol, just realized most of the discoloring around the trailing arm and axle is from wd40 to break bolts loose. You can't see the axle seal leaks in the picture. Sent from my SAMSUNG-SM-N900A using Tapatalk- kidphc
- Post #7
- Forum: 1st Gen - 1997 - 2002
-
K
A couple of rear axle questions
Small axle leak from both seals, verified after a wheel pull. The color difference on the axle, is due to some under coating that we sprayed after getting off surface rust. It's temporary till I can get the rust grinding wheel from my dad's lake house. I did a conversion on the air springs. The...- kidphc
- Post #6
- Forum: 1st Gen - 1997 - 2002
-
K
A couple of rear axle questions
Vent line for rear axle on my 98 is on driver side, by the spring. Hose runs into the frame.- kidphc
- Post #3
- Forum: 1st Gen - 1997 - 2002
-
K
P0453
The Pinpoint says it has to do with the FTP Sensor Voltage or it's not reading enough pressure in the tank (hence the low voltage). FROM ALL DATA PINPOINT Z1 is a basic BS (bull Sh*) pinpoint test sheet. Since it occurred after a fill up. Maybe you didn't tighten the gas cap or the gas cap...- kidphc
- Post #2
- Forum: 1st Gen - 1997 - 2002
-
K
How to disable perimeter lighting (change to fogs or aux if you like)
Awesome. Vote to FAQ... Hmmm. I can't find anything in FAQ. Ok Vote To Generation 1 Technical Stickie.. Then. Errrh... I hate to see this article get buried in Tech Info.- kidphc
- Post #4
- Forum: 1st Gen - 1997 - 2002
-
K
01 Exp Rubber Vaccum Manifold Question
It's a speciality vacuum connector for Fords. We've replaced several on Taurus and Sables here at the shop. You are going to have a tough time finding it anywhere but the dealer, to be honest. A lot of times, we just build connectors using vacuum T's. Wish I could tell you what sizes we used...- kidphc
- Post #2
- Forum: 1st Gen - 1997 - 2002
