UPDATE:
It was a bit of a PITA but I got it running today. Rewired the fuel pump. Started right up. Idles a little rough but that should clear up once the vacuum lines are fixed. Thanks for all the help guys!
Alright guys I got an update. Dropped the tank to check the wiring to the pump. The wiring for the pump is MISSING. I'm assuming whatever chewed up the vacuum lines had built a nest on top of the fuel tank and literally eaten the wires down to the plastic on the fuel pump. So looks like I'm...
Finally got some time to work on the Expy. Fixed all grounds that (I can find) that are bad (broken. There were several of them). I also tested voltage to inertia switch (12v for second or 2 then drops to 6v, which I believe is normal. Correct me if I'm wrong). Anyone know what color the hot...
Got some time to work on it before the storms rolled in today. Starts on starting fluid. Fuel delivery problem. When you turn ignition to run (without trying to start it) there is a loud clicking coming from fuse panel (assuming the fuel pump relay). Can't tell if the fuel pump is coming on or...
Thanks a lot for the pics and info. Haven't had much time to work on it last few days. Will hopefully have some time this week/weekend. Will update as I go.
Didn't give much of anything for it. It was damn near free
Thanks for the help. Added this pic from yours. The wire by the red arrow has been cut off at the firewall on mine and I have no idea where it goes. Also the ground strap right above passenger side head on firewall is broken and I do not know where it goes either
If you have any more under...
I have a 2003 Eddie Bauer 4.6L Expedition. All vacuum lines are gone and wires have been cut. Ground straps are messed up, and hot wire was cut. Would someone mind taking an under hood pics of engine for me please? I'm not sure what is missing and what is just cut. As you know it obviously won't...
Is there any way possible I could get you to measure your rear control arms for me? I'm building my own lift and can't seem to find any measurements for the control arms
It's a bit of a pain. You have to remove the plastic cover on the radiator support. Remove the side markers. Remove the plastic pieces from between the bottom of the grill that covers the gap between the grill and bumper (not the piece on top of bumper). Remove all the screws in the grill (can't...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.