Can anyone help me find the vertical beam adjuster? (see attached photo). I am in the process of retrofitting HID projectors into my headlights and I broke the black plastic rod that moves the reflector. I've attempted a JBWeld repair but it is not satisfactory. All I need is that gear driven...
Hey Gixer....thanks for your informative posts....your work is first rate
I drive a mint 2009 Limited (46K) miles.....a lot of elbow grease needed to keep black paint looking pretty. I've been running aftermarket Anzo halogen projectors (I know yuck) for the last couple of years and now it's...
I have a 09 Limited.....I was able to separate the lens from the housing with some careful prying and a Dremel tool....resealed it with clear silicone.....still working fine after 2 yrs
Hi Jayson,
I had a similar issue when I replaced the incandescent tail light bulbs with LED's on my '10 Limited. I finally had to install resistors (one per side on the flasher circuit) to correct the fast flash problem.
BTW: Don't know about your '08, but my '10 did not have a flasher that...
LED brake light
I have replaced the rear bulbs with a pair of Philips 3157 Vision red LED. I drive a 2009 Limited and the rear bulbs are multi function (stop, tail, directional).
I had to wire in a resistor to eliminate hyper flashing, the other functions operated normally.
Bob D
I also purchased a discounted set if Anzo headlights. They were sold "as new, open box". There were no bulbs in the box but I installed Philips X-treme Vision hi/low beams. The headlights are a huge improvements over stock. I couldn't get the CCFL halos to work, problem was two bad inverters...
I purchased a set of BMW LED fog lights from Retrofit Source. Had to fabricate brackets,the BMW mounts had nothing in common with the Ford. The final result was good, the light pattern from the BMW fogs is excellent.
I had the same front passenger side sloppy fit issue with my Weathertech liners. Fixed it by punching a hole in the passenger side kick panel, being careful not to hit any wires, and a matching hole in the floor liner. I used a plastic anchor to fasten the two together. The liner now does not...
Hello everybody....2009 Expedition Limited (not EL) 4x4
I'd like to install LED tail lights and I want to replace flasher as an alternative to installing resistors. Even with a shop manual, I can't find the turn signal flasher....help!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.