2011

  1. Digital_Dad

    2011 Expedition 5.4l 3v P0301 Cylinder 1 Misfire

    It has a permanent P0301 that doesn't erase when codes are cleared 2011 Expedition 5.4l 3v Started by swapping the #1 coil with the #2 coil, erasing codes and starting it up and rerunning the code reader, still get P0301, so swapped plugs between 1 & 2, erased codes ran it and reran codes got...
  2. hawkman71

    Flashing check engine light upon hard acceleration. P2096 only code: "Post cat fuel trim sys too lean bank 1"

    Hi y'all. I did a search on this forum for "P2096" as well as the full message in the thread title (post catalyst system too lean bank 1) and haven't found what I need. I have a 2011 Exped with only 150k on it that has given us its fair share of problems over the years. However, when it runs...
  3. R

    New to me 2011 Expo King Ranch 130k spark plugs

    Purchased a new to me 2011 Expo King Ranch with 130k mi. When I test drove it, I could feel the rough idle and at wide open throttle it hesitated and the check engine light flashed momentarily. Code scanner didn't display any permanent codes, only a pending misfire on cylinder 6. I knew from...
  4. H

    Lack of acceleration after 1st gear. Clogged cat?

    Hey everyone, I've got a 2011 expy with 170K miles on it and I'm starting to experience a major lack of acceleration after shifting into 2nd gear and above. I just replaced the spark plugs and coil packs so I don't think those are the problem. My suspected issue is a clogged cat (I owned an...
  5. TDGFordGuy

    2013 Traction Control Light Blinking and Power Loss

    While turning left through a very rough California intersection, the traction control light came on and blinking and truck immediately began slowing down and total loss of power until I fully let up on the gas pedal. Light goes off, all back to normal. Make another left turn onto the freeway...
Top