joedmti
Member
Blend Door
go to heatertreater.net
They show you to get to the front blend door, but not the rear.
For get the blend door, eyeball that water pump.
Anynoodles, the rear blend door is accessed from the inside of the truck.
Pull the third seat out, and start digging the plastic and trim out of the driver side rear wheel well.
The heatertreater.net video will show you how to rip and strip your front interior to replace the blend door.
Before you go wild and start the tear down, I suggest you get an eyeball on the blend door. And while you are there, you can feel the heater core and see if she gets hot. To get a visual on the front blend door, just drop the glove box door, get out your dremel tool, cut the back of the glove box out,
then cut the black plastic plenum across the top, the vertically down the right and left side, then remove the 2 bolts w an 8mm ratchet.
Once the plenum has been removed, you will see the blend door on the left.
Turn the heat/cool knob, see if the door opens and closes. (My guess is it is)
Check the heater core, its on the left, bet she's cool.
Put the plenum back, and get yourself some silicone to seal it in place.......
go to heatertreater.net
They show you to get to the front blend door, but not the rear.
For get the blend door, eyeball that water pump.
Anynoodles, the rear blend door is accessed from the inside of the truck.
Pull the third seat out, and start digging the plastic and trim out of the driver side rear wheel well.
The heatertreater.net video will show you how to rip and strip your front interior to replace the blend door.
Before you go wild and start the tear down, I suggest you get an eyeball on the blend door. And while you are there, you can feel the heater core and see if she gets hot. To get a visual on the front blend door, just drop the glove box door, get out your dremel tool, cut the back of the glove box out,
then cut the black plastic plenum across the top, the vertically down the right and left side, then remove the 2 bolts w an 8mm ratchet.
Once the plenum has been removed, you will see the blend door on the left.
Turn the heat/cool knob, see if the door opens and closes. (My guess is it is)
Check the heater core, its on the left, bet she's cool.
Put the plenum back, and get yourself some silicone to seal it in place.......