I rarely use a torque wrench and never had a problem. People think mechanics keep one in their back pocket but it's not true. A few lines on cams never hurt anything either. Andy; don't worry about breaking bolts, it rarely happens.
Only if it has the optional tow package with the supposedly bigger radiator, trailer brake controller, 7 pin connector (obvious one in the back with the flip up lid), and the auto trans cooler.
I have been aligning my wheels with strings and bubble levels for about 50 years with NO problems, I can't remember the last time I had a shop do it. OK everybody squawk NOW!
I think the back spacing etc is the same but you would have to cut about 1/2" off your rear axles to clear the center caps.....what a deal! I have some PVD wheels that are losing "chrome" around the edge and I am trying to figure out the best way to repair them. I would use an angle grinder with...
I agree, unless there is a ZF trans in it but that's not sealed either. The Ford "dipstick" is on the pass side towards the back and it's about 2"+- long.
I had AAA and used it one time when I ran out of gas but I had to wait an hour for them to give me exactly one gallon and I couldn't pay for any extra. That was the end of AAA.
If you have the ZF transmission you will only have a fill hole but IDK if any of the Expys have that trans. They did put them in the Navigators for some reason.
It's just that I don't believe in them. The Ford trucks already have a cold air intake and are engineered for the stock setup. They have more than enough air intake up to at least top RPM. The engineers aren't going to shortchange their own induction system. As for the plugs; the plugs can have...
And everything works perfectly? No clunks, 4wd problems, 4 auto problems, vibrations, etc? If you mark the tire, how far will it turn before turning the axle with just one side jacked up?
The ones on my last 2 modular engines were clean at high miles too but I think it's common if you change your air filter on time and don't fall for that aftermarket cold air intake hogwash. IDK about the catch can advantage on your boosted motors..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.