-
-
Thanks everyone, I have been noting the mileage at every fill up and the amount of fuel I add, my calculated mpg and the displayed mpg... -
GlennSullivan replied to the thread Reduction in MPG.Above suggestions for O2 sensors and partially plugged CAT make sense. I would add that you also do a manual fuel mile calculation...
-
I wish. Not even close :)
-
GlennSullivan replied to the thread Gen 5 photos!.It is beautiful. Over 100K?
-
GlennSullivan replied to the thread Gen 5 photos!.Links don't work. Use the attach file button just below the text area.
-
-
GlennSullivan replied to the thread Anyone Know Where To Source A 20" Steel Spare Wheel.On the same subject, but different part, Tire Pressure Sensor / Valve assembly. Does anyone know the correct MotorCraft / Ford...
-
GlennSullivan reacted to waveslayer's post in the thread Anyone Know Where To Source A 20" Steel Spare Wheel with
Like.
I did the same thing with several of my trucks, I went on Facebook Marketplace as well as ebay. Also, sometimes Craigs List. -
GlennSullivan replied to the thread Anyone Know Where To Source A 20" Steel Spare Wheel.Actually, the center hole on the steel (spare) wheel is larger and when I tried to fit it, I did so with the truck on my lift, so it was...
-
GlennSullivan posted the thread Anyone Know Where To Source A 20" Steel Spare Wheel in 3rd Gen Ford Expedition Wheels, Tires & Brakes.I talked about this a few years back. I trailer long distances a fair amount and in the case of getting a flat on one of the truck...
-
Good morning, I'm looking for a quotation on TPS Valves and have a question about a 20" steel spare wheel 2017 Expedition Limited VIN -...
-
GlennSullivan replied to the thread 2WD or AWD?.I'm with Doug, Have always purchased 4 wheel drive SUVs. Lived in the north most of my life where it was required, even now, where we...
-
GlennSullivan replied to the thread Ugh P07E6 = Trans Time.How much is this costing you and what warranty do you get when complete?
-
GlennSullivan replied to the thread Engine locking up.In reading this with it first running OK after repair and then hard locking, with only way to unlock is to reverse rotate, I'm thinking...
-
GlennSullivan replied to the thread Power Running Board Motor Availability.That is interesting, didn't think of that.
-
GlennSullivan posted the thread Power Running Board Motor Availability in 3rd Gen Ford Expedition General Discussion.FYI - From time to time I see a post where someone is looking to replace power running board motors on a Gen 3 and sees that Ford only...
-
-
-
Loading…
-
Loading…
