Recent content by Brucell
-
B
Let's play... guess the repair bill total!
A new/rebuilt motor would most likely cost about the same…thank God you have the extended warrantee. By the way, did you purchase it from one of the phone solicitors ?- Brucell
- Post #3
- Forum: 3rd Gen Ford Expedition General Discussion
-
B
O2 Sensor Heater Issue All 4 Bad at Once?
In the picture above, this is C146. The green wire pin was corroded. Gave me all sorts of codes, P0446, P0155, P0135, P0161, P0141. The corrosion was just a small green, blackish looking dot on the pin. Good luck. Thanks everyone for the post above.- Brucell
- Post #15
- Forum: 3rd Gen Ford Expedition Engine & Performance
-
B
O2 Sensor Heater Issue All 4 Bad at Once?
I can not find a solution to fix this confounded issue.- Brucell
- Post #12
- Forum: 3rd Gen Ford Expedition Engine & Performance
-
B
Check Engine Light-O2 Sensors not bad…?
Here are the pictures…- Brucell
- Post #2
- Forum: 3rd Gen Ford Expedition Engine & Performance
-
B
Check Engine Light-O2 Sensors not bad…?
I have a 2012 XLT. Yesterday the Check Engine light came on. Codes were O2 sensors. Bank 1 Sensors 1 & 2. Went and bought new ones, replaced them…easy. Well, not so easy. Seems other have had similar issues. The forum said look for Plug C146-It's the green wire that is corroded. No such plug...- Brucell
- Thread
- Replies: 1
- Forum: 3rd Gen Ford Expedition Engine & Performance
