Ya, the coils where new on EBAY units (seller had perfect feedback) i would suspect they are cheap knock offs.. maybe the heat got to um.. its just so strange, thouhgt I would see if there was any wierd thing with these year Fords..
17.. well this was a 200 mile stretch with the "fill till...
GM cars from 99 to 2006 (grand am, Alero, malibu,) all use plastic on bottom of windows to attach to the wind crank mechanics.. in the cold they snap like .. well cold plastic.. take your hands press them on teh glass and just jherk down as hard as you can.. snaps um right off. Little harder in...
Ok my Expy is 98 with 4.6 with 180,000 When I bought it the back passenger cylinder was missing. I replaced coils (this is not the ones with one per plug setup) wires and plugs and it ran like a champ. I recently took it on its first extended trip. I pulled a trailer (small open one) 400 miles...
feel foolish asking-oil filter
I been tinkering with my Expy for about a year, and its time for an oil change (dont get to excited, was suposed to be done when i got it). I noticed when i was working on the exhuast manifold there was an oil filter in the drivers side front fender behindthe...
I have this same problem.. but its 70-75.. very annoyting.. 77 and its gone.. just enough.. to sadly get picked up (yes i have a ticket for 77 in a 75 zone!)
I cant see it being tires or rims if its such a small specific spot. it really is 5 -6 MPH stretch.. 70, nothing.. it slowly ramps at...
I have a freind with an exhaust shop and he hates these trucks.. Mine had a bad bolt from the manifold to the pipe. he gives me a deal on exhuast work as he is a freind, saw my truck and looked like he was about to cry. he said he would do it.. but to expect big bucks even with a cut rate deal...
I read pretty fast.. when you let off gas, i doubt thats U-joints. Still could bt a bent rim or tires... or even somthing lose in frontend, bushing as you mention... Im pretty new to the Expy so my knowledge is limted to 'all cars' not sure if there are specific stuff ont eh expy to look for.
Keep in mind.. you want louder.. fine.. but louder out back of truck and louder under you are Two complelty differnt things...That extra 5-8 feet of pipe to pipe it out the back will be huge. I have had trucks and cars with Sidepipes, and stacks.. and lets just say .. each time i regretted it on...
Bad U Joint? Mine has a bad vibration that just showed up, I have had several bad u-joints and mine feels like it.. but wont know till i replace um (cheap, about $15 each and some work). of course it could be a betn rim, a tire with a problem.. they do work fine and bust a cord sometimes...
After readin here I must admit I was quite worried. I bouhgt a set of extensions at the local tool harbor that locked onto the sockets ofr $14 (made job 100% easier than it would have been). YOU WILL NEED air.. to blow out the holes, otherwise .. just work,, nothing out of ordinary .. I would...
gotta agree with the "how well was it taken care of" statement. Most new cars of any make should be able to make 200,000 with mild care. Tech, oil, etc has improved so much in the last 20 years or so. there is something to be aid about design.. in the past there where simple flaws but even many...
lots of good advice.. and a bit "as I thought" no Known bad spots it seems, just all the standards..
I may be wrong on Wheel bearings.. I have had a couple of newer cars with the same clunk with bad wheel bearings.. all front wheel drive cars.. after they changed from old style angled...
98 expy, when i go around a corner and hit any kind of bump i sometime hear a small clunk. I dont think its CV joints as the standard sharp corners in forward and reverse to test produce no noise.. you need to hit some kind of bump. Bearings.. again doubtfull this is not a huge clunk.. but a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.