I looked for a left out wire at the battery terminals, all positive and negative wires at battery are bolted together. They are all attached and i tested for power/conductivity and all are good.
With the ignition key turned on but motor not running, i back probed all fuses with a multi-meter...
Help. I recently replaced my battery, as it was old and tired. After i installed the new battery, my truck starts up great, but the radio does not work. I checked the fuses under the kick panel, and they are all good. i checked power behind the radio (it is after market unit i installed 5...
Work complete
I replaced the front rotors and brake pads yesterday. I bled the brakes and tested the calipers, which seemed to operate smoothly. I removed the guide pin boots and discovered rust build up under the rubber boot. This seemed to have caused the pins to bind and not slide easily...
See attached photos
The inside pad needs to be replaced but not down to metal on metal
I almost seems like the calipers which are on the inside are not pushing the pad against the rotor?
I have a 2007 Expedition XLT with 98k miles. I recently inspected by front brakes and found both rotors are rusted under the brake pads on the inside only of both rotors. The outside of the rotors under the pads are clean/smooth as normal.
I have always kept the guide pins lubricated...
The satellite radio antenna lead end can be found in the center console.
To get to it you need to carefully pry up the trim around the gear shift, remove the one screw located under the rubber junk tray, and carefully pry up the top trim of the console. The satellite radio antenna cable is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.