Recent content by dominus
-
D
Projector Headlights w/ Halo Ring
I have the same headlights. You need to tap the turn/parking light wires for + and - . A plastic wire tap works best. That makes the leds work when you have the parking lights on or full headlights. The main headlight simple plugs into the stock headlight connector. The silly 2 other...- dominus
- Post #2
- Forum: After Market Add-Ons
-
D
Where to ground?????
Some times its not a electrical problem at all. If you have the gain set to high on the amp you will get a hiss from the speakers. You can try lowering it most amps have a small control for just this purpose. Set it to min if you still have noise that rules out a gain problem. Its also a...- dominus
- Post #7
- Forum: Electrical
-
D
Drop Down monitor
I think you are talking about the rear AC/Heat controls on the roof? If so, I just removed that unit when I installed a drop down monitor/dvd player. That gives you a nice place to attach a wooden block to the metal roof to screw the monitor to. The indent that it leaves can be covered over...- dominus
- Post #2
- Forum: Electrical
-
D
How to remove front seats
Hello, can anyone help me out with removing the front seats in my 97 expedition. The only torex wrench I could find is a l wrench and I can't losen the floor bolts with. Am I missing something here? I want to install a kenwood dash pop up monitor and put the brain unit under the passenger...- dominus
- Thread
- Replies: 0
- Forum: General Discussion
-
D
Flip down install?
You don't need to remove the head liner, but it won't support 3 monitors. What I did was cut a hole in the liner, and glue a piece of wood to the roof then used that to mount the monitors.- dominus
- Post #2
- Forum: After Market Add-Ons
-
D
Wiring new mirror in 97 expy
Hi, Any help you could give would be great. I need a wire which is hot when the ignition is on for a new day night mirror. I have a hayes manual, but finding the lt blu/ Pnk wire is not easy. Any idea on which one to tap?- dominus
- Thread
- Replies: 1
- Forum: Electrical
-
D
4 wheel not working on 98 exped
Thanks - it turned out to be a vac seal. almost $400 for my ford dealer to replace it. All is working fine again.- dominus
- Post #3
- Forum: Transmission & Drive train
-
D
4 wheel not working on 98 exped
Has anyone else had a problem with 4 wheel high? I have a 98 xlt exped. When I set the dash switch to 4 wheel high, auto 4 wheel or 4 wheel low power only goes to the rear wheels. I just got stuck in the snow because my front wheels where not getting any power. I have 20 inch rims with...- dominus
- Thread
- Replies: 2
- Forum: Transmission & Drive train
