Recent content by Donald Bell
-
D
Transmission Missed Shift/Slip
I just recently started having the same problem happen but I can't go forward when I press the gas it just revs up. I let my foot of the gas and it take another moment or so then catches and goes forward- Donald Bell
- Post #7
- Forum: 2nd Gen - 2003 - 2006
-
D
Vacuum Line Connection?
Does it seem as though you have a loss in power when trying to accelerate? Like it's struggling to get up like after 1/2 gear you finally feel your truck translating power properly? I'm asking because if I remember correctly those may be codes for your truck riding "lean" or "too much air in...- Donald Bell
- Post #2
- Forum: 2nd Gen - 2003 - 2006
-
D
Taking care of him!
For starters, truck is running well, no current alarming problems but, I know BIG GUY needs work! I"ve taken great care of her since I've owned him (2 years). I'm going to be taking him to the shop to get a full rooter to tooter inspection and diagnostics and I'm willing to fix ANY and EVERY...- Donald Bell
- Thread
- Replies: 1
- Forum: 2nd Gen - 2003 - 2006
-
D
How many miles on your 2nd Gen Ford Expedition?
West Carrollton, OH 2004 Eddie Bauer 5.4L 2V AWD HD 4x4 175,000 miles Owned for 2 years (146,000 miles when bought) 2nd owner Love her to death! New break lines, Rocker panels, all suspension redone, brakes/rotars/pads replaced, 2 inch lift in the front, 1.5inch spacers on all 4 corners...- Donald Bell
- Post #134
- Forum: 2nd Gen - 2003 - 2006
-
D
catch can benefit
How much does one usually cost? A great one??- Donald Bell
- Post #28
- Forum: 2nd Gen - 2003 - 2006
-
D
Lets see those lifted Expedition's!
I was thinking about that as well but for the ford F-150 they made from 2003-07 they don't have that badge only the 4x4 and 4x4 off-road decals. The ones I have on there now are the 2007-2013 F-150 decals. I want to the appropriate gen decal on mine is all- Donald Bell
- Post #11
- Forum: New Member Check-In
-
D
Lets see those lifted Expedition's!
- Donald Bell
- Post #9
- Forum: New Member Check-In
-
D
Lets see those lifted Expedition's!
Yessir 1.5 inches on all 4 corners. 4x4 and pin stripes are gold but I just found the pin stripes in the Arizona Biege that matches the bottom trim and I'm going to swap out the 4x4 decal with red ones- Donald Bell
- Post #8
- Forum: New Member Check-In
-
D
Lets see those lifted Expedition's!
- Donald Bell
- Post #6
- Forum: New Member Check-In
-
D
Lets see those lifted Expedition's!
Looks great, was thinking of running 22x12s with 33x12.50R22s but I'm not sure they'll fit! I have a 2.0 leveling kit in front stock in back running boards have been removed also- Donald Bell
- Post #4
- Forum: New Member Check-In
-
D
Lets see those lifted Expedition's!
What size tires/rims are you running- Donald Bell
- Post #2
- Forum: New Member Check-In
-
D
22x10s w/off-road tires?????
Nah I don't plan to go any bigger than 33s. I have 285/70/r17s on right now which are equal to 33s in diameter but about 2 inches shorter on width. I'm also looking at a set of 285/45/R22 venom power A/T tires which after your review I'm sure I'll probably go with those! Thank you- Donald Bell
- Post #9
- Forum: 2nd Gen - 2003 - 2006
-
D
Rattle noise when starting
Could also be bad water pump and worn water pump belt. Could be cam phaser lifters as well- Donald Bell
- Post #4
- Forum: 2nd Gen - 2003 - 2006
-
D
Shop recommendations
Np! Was going to say check oil filter or water pump! Mine would rattle on start up then go away as well. Just had my serpentine belt, water pump, water pump hoses and belt as well as oil filter and high milage cleanser care and sealer oil put in her and she roars again- Donald Bell
- Post #4
- Forum: 2nd Gen - 2003 - 2006
Latest posts
-
-
-
2006 EB Rear HVAC Inoperable / Fuse, Relay, Resistor Good- Latest: 2006Overlander
-